Page 81 / 162
Scroll up to view Page 76 - 80
72
2.
Configure [Administration Interface] Settings based on the instructions listed below.
Administrator Password
Maximum input is 36 alphanumeric characters (case sensitive)
* Please change the administrator‘s password if the remote management
is enabled. Otherwise, a malicious user can access the management
interface. This user can then have the ability to change the settings and
interrupt your network access.
Re-type Password
Enter the password again to confirm.
Remote Management
Select Enable to enable Remote Management.
Select Disable to disable Remote Management
If the remote management is enabled, users who are not in the LAN can
connect to the ZyXEL VFG6005 Series VPN Firewall Gateway and
configure it from the Internet.
Management Port
HTTP port which users can connect to. (default port is 80)
3.
Configure [Configuration] Settings based on the instructions listed below
Configuration Export
Click Export to save your current configuration settings in a file.
Default Configuration
Restore
Click Default to recover the default system settings.
Configuration Import
Click Browse and Import to load previous configuration settings.
4.
Configure [Firmware] Settings based on the instructions listed below
Firmware Upgrade
Click Browse and Upgrade to upgrade the firmware.
Page 82 / 162
73
10.2 SYSTEM UTILITIES
1.
Click on [Admin]
–
[System Utilities] tab. You will see the following screen.
Page 83 / 162
74
2.
Using the [ping] tool based on the instructions listed below
Interface
Select the interface that you want to use to ping from, i.e. LAN, WAN.
Target Host
Enter the IP address to ping to
Number of Packets
Specify the number of the ICMP packets to send out
Ping
Press the tab to start the ―ping‖ actions
3.
Using the [ARPing] tool based on the instructions listed below
Interface
Select the interface that use to ARPing to, i.e. LAN, WAN.
Target Host
Enter the MAC address to ARPing to
Number of Packets
Specify the number of the ARP request packets to send out
ARPing
Press the tab to start the ―ARPing‖ actions
4.
Using the [Trace Route] tool based on the instructions listed below
Interface
Select the interface that use to ARPing to, i.e. WAN1, WAN2.
Target Host
Enter the destination IP address / domain name to trace
Hop Count
Specify the Hop number you need to trace
Trace route
Press the tab to
start the ―Trace Route‖ actions
Page 84 / 162
75
10.3 TIME SETUP
5.
Click on [Admin]
–
[Time] tab. You will see the following screen.
6.
Configure [Time] Settings based on the instructions listed below
Time Synchronization
Select Enable/Disable to enable/disable Time Synchronization
Time Server Type
Select Time Server Pool or Manual.
Time Server Area
Select Time Server according to your location. You can choose from
Automatic, Asia, Europe, North America, South America, or Africa.
Time Zone
Select Time Zone according to your location.
Periodic Synchronization
Select Enable/Disable to enable/disable Periodic Synchronization
Daylight Savings
Support
Select Enable/Disable to enable/disable Daylight Savings Time.
Synchronization Interval
Select from Every Hour, Every 6 Hours, Every 12 Hours, Every Day, and
Every Week.
Action
Click update to update the Time Settings immediately.
Page 85 / 162
76
10.4 LOG
1.
Click on [Admin]
–
[Log] tab. You will see the following screen.
19216811.live