Chapter 11 Filters
P-660HN-TxA User’s Guide
159
Rule Type
Select
IP
or
MAC
type to configure the rule.
Use the
IP Filter
to block traffic by IP addresses.
Use the
MAC Filter
to block traffic by MAC address.
Active
Use this field to enable or disable the rule.
Source IP Address
Enter the source IP address of the packets you wish to filter.
This field is ignored if it is 0.0.0.0.
Subnet Mask
Enter the IP subnet mask for the source IP address
Port Number
Enter the source port of the packets that you wish to filter. The
range of this field is 0 to 65535. This field is ignored if it is 0.
Destination IP Address
Enter the destination IP address of the packets you wish to
filter. This field is ignored if it is 0.0.0.0.
Subnet Mask
Enter the IP subnet mask for the destination IP address.
Port Number
Enter the destination port of the packets that you wish to filter.
The range of this field is 0 to 65535. This field is ignored if it is
0.
Protocol
Select
ICMP
,
TCP
or
UDP
for the upper layer protocol.
MAC Address
This field is only available when you select
MAC
in the
Rule
Type
field.
Enter the MAC address of the packets you wish to filter.
Rule Unmatched
Select the action for a packet not matching the rule.
Select
Forward
to forward traffic immediately and skip
checking the remaining rules. Select
Next
to check the next
rule.
IP/MAC Filter Listing
IP/MAC Filter Set Index
Select the index number of the filter set from the drop-downl
list box.
Interface
This is the interface that the filter set applies to.
Direction
The filter set applies to this traffic direction.
#
This is the index number of the rule in a filter set.
Active
This field shows whether the rule is activated.
Src Address/Mask
This is the source IP address and subnet mask when you select
IP
as the rule type.
This is the MAC address when you select
MAC
as the rule type.
Dest IP/Mask
This is the destination IP address and subnet mask.
Src Port
This is the source port number.
Dest Port
This is the destination port number.
Protocol
This is the upper layer protocol.
Unmatched
When a packet doesn’t match the rule, this is the action the
ZyXEL Device takes on the packet.
SAVE
Click this to save your changes.
Table 52
Access Management > Filter (IP/MAC) (continued)
LABEL
DESCRIPTION
19216811.live