Page 216 / 296
Scroll up to view Page 211 - 215
Chapter 23 Sys Op Mode
NBG334W User’s Guide
216
Figure 127
IP Address in AP Mode
23.2
Selecting System Operation Mode
Use this screen to select how you connect to the Internet.
Figure 128
Maintenance > Sys OP Mode > General
If you select Router Mode, the following pop-up message window appears.
Figure 129
Maintenance > Sys Op Mode > General: Router
•
In this mode there are both LAN and WAN ports. The LAN Ethernet and WAN Ethernet
ports have different IP addresses.
•
The DHCP server on your device is enabled and allocates IP addresses to other devices on
your local network.
•
The LAN IP address of the device on the local network is set to
192.168.1.1.
•
You can configure the IP address settings on your WAN port. Contact your ISP or system
administrator for more information on appropriate settings.
If you select Access Point the following pop-up message window appears.
1 IP
LAN
Internet
Page 217 / 296
Chapter 23 Sys Op Mode
NBG334W User’s Guide
217
Figure 130
Maintenance > Sys Op Mode > General: AP
• In
AP Mode
all Ethernet ports have the same IP address.
•
All ports on the rear panel of the device are LAN ports, including the port labeled WAN.
There is no WAN port.
•
The DHCP server on your device is disabled. In AP mode there must be a device with a
DHCP server on your network such as a router or gateway which can allocate IP
addresses.
The IP address of the device on the local network is set to
192.168.1.1.
The following table describes the labels in the
General
screen.
Table 99
Maintenance > Sys OP Mode > General
"
If you select the incorrect System Operation Mode you cannot connect to the
Internet.
LABEL
DESCRIPTION
System Operation Mode
Router
Select
Router
if your device routes traffic between a local network and another
network such as the Internet. This mode offers services such as a firewall or
bandwidth management.
Access Point
Select
Access Point
if your device bridges traffic between clients on the same
network.
Apply
Click
Apply
to save your settings.
Reset
Click
Reset
to return your settings to the default (
Router
)
Page 219 / 296
NBG334W User’s Guide
219
C
HAPTER
24
Language
Use this screen to change the language for the web configurator display.
24.1
Language Screen
Click the language you prefer. The web configurator language changes after a while without
restarting the NBG334W.
Figure 131
Language
19216811.live