Page 16 / 89 Scroll up to view Page 11 - 15
Chapter 2 - Product Installation
For wireless access, an external or built-in 802.11b/g/n wireless adapter is
required.
To configure the system via the web page based interface, you need a
web browser such as Internet Explorer (version6.0 or above), Netscape
(version4.7 or above).
Proprietary Information of ZTE CORPORATION
5
Page 17 / 89
ZXV10 W300 (V5.2) Wireless ADSL Router Maintenance Manual
This page is intentionally blank.
6
Proprietary Information of ZTE CORPORATION
Page 18 / 89
C h a p t e r
2
Product Installation
This chapter shows hardware connections for installing W300, presents
factory default settings, and describes how to configure a computer for using
W300.
Hardware Connections
1.
Place the W300 router on the plane surface. Minimize obstacles and the
distance between the W300 router and the wireless terminal.
2.
ADSL/Ethernet uplink connection
A W300 router can access the ISP’s network in either ADSL uplink mode
or Ethernet uplink mode.
ADSL uplink
The user is suggested to adopt the following connection method for ADS
L uplink mode, as shown in Figure 3.
Proprietary Information of ZTE CORPORATION
7
Page 19 / 89
F
I G U R E
3 ADSL U
P LI N K
C
O N N E C T I O NS
If a telephone needs to be installed in front of the splitter, the user must
connect a voice filter in the Line port of the splitter; then connect the ph
one to the splitter’s Phone port. The other port connections can be referr
ed to Figure 3.
A splitter consists of three ports:
Line: The port connected to the ADSL subscriber line.
Modem: The port connected to the W300’s LINE port.
Phone: The port connected to a phone.
Ethernet uplink
Port connections for Ethernet uplink mode can be referred to Figure 4. C
onnect one end of the RJ-45 Ethernet cable to the W300’s LAN1 port, an
d another end to the ISP’s network.
Proprietary Information of ZTE CORPORATION
8
Page 20 / 89
Chapter 2 - Product Installation
F
I G U R E
4 E
T H E R N E T
U
P LI N K
C
O N N E C T I O NS
3.
Use an RJ-45 cable to connect the W300’s
LAN4
port to a computer or
another network device.
4.
Connect the power adapter to the device and plug the power adapter to
the AC power outlet. W300 will be on after pushing the power switch bu
tton.
Caution:
Please use the companion power adapter. The other power adaptor may mak
e W300 unable to work normally or even damage it.
Proprietary Information of ZTE CORPORATION
9

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top