Page 81 / 208
Scroll up to view Page 76 - 80
80
CONNECTIONS
05
/ USING NETWORK
1.
In the Wireless Access Point Properties page, click
Settings
.
The configuration page displays.
2.
Verify the following information:
•
Status
- displays the connection status of the network.
•
Network
– displays the type of network connection.
•
Connection Type
- displays the type of connection.
•
Physical Address
- displays the physical address of the
network card used for the network.
•
MTU
- specifies the largest packet size permitted for
Internet transmissions:
verizon.com/fios
|
©
2014 Verizon. All Rights Reserved.
Page 82 / 208
–
Automatic
- set the MTU (Maximum Transmission
Unit) at 1500
–
Automatic by DHCP
- sets the MTU according to the
DHCP connection
–
Manual
- allows you to manually set the MTU
3.
Click
Apply
to save changes.
5.4/
BROADBAND ETHERNET/COAX CONNECTION
A Broadband Ethernet connection connects computers to your
Gateway using Ethernet cables. The connections are either direct or
use network hubs and switches.
A Coax connection connects devices, such as set-top boxes, to your
Gateway using a coaxial cable.
Note:
If disabling the connection, you must reboot your Gateway for the
change to take effect.
To view the connection:
1.
In the Network Connections page, click the
Broadband
Connection (Ethernet/Coax)
link.
WIRELESS ACCESS POINT CONNECTION AND
BROADBAND ETHERNET/COAX CONNECTION
Page 83 / 208
82
CONNECTIONS
05
/ USING NETWORK
2.
To rename the network connection, enter the new name in
the
Name
field.
3.
Click
Apply
to save changes.
5.4a/
CONFIGURING THE ETHERNET/COAX CONNECTION
To configure the connection:
1.
In the Broadband Connection (Ethernet/Coax) Properties
page, click
Settings
. The configuration page displays.
verizon.com/fios
|
©
2014 Verizon. All Rights Reserved.
Page 84 / 208
2.
Configure the following settings, as needed.
GENERAL
Verify the following information:
•
Status
- displays the connection status of the network
•
Network
– displays the type of network connection
•
Connection Type
- displays the type of connection
•
Physical Address
- displays the physical address of the
network card used for the network
•
MTU
- specifies the largest packet size permitted for
Internet transmissions:
–
Automatic
- set the MTU (Maximum Transmission Unit) at
1500
BROADBAND ETHERNET/COAX
CONNECTION
Page 85 / 208
84
CONNECTIONS
05
/ USING NETWORK
–
Automatic by DHCP
- sets the MTU according to the
DHCP connection
–
Manual
- allows you to manually set the MTU
COAX LINK
1.
To set the Channel, select the coax link channel as 1 to 3.
2.
Select the
On
or
Off
radio button in the Auto Detection field.
3.
To set privacy, select the
Enabled
check box. This causes
all devices connected to the coaxial cable to use the same
password. This is recommended.
4.
To set the password, enter the Coax Link password in the
Password
field.
5.
To enable or disable the Coax link, click
Disable
or
Enable
.
6.
To view the devices connected using the coaxial cable, click
the
Go to WAN Coax Stats
link.
verizon.com/fios
|
©
2014 Verizon. All Rights Reserved.
19216811.live