Page 76 / 208
Scroll up to view Page 71 - 75
ETHERNET/COAX
CONNECTION
2.
To rename the network connection, enter the new name in
the
Name
field.
3.
Click
Apply
to save changes.
5.2a/
CONFIGURING THE ETHERNET/COAX CONNECTION
To configure the connection:
1.
In the Broadband Connection (Ethernet/Coax) Properties
page, click
Settings
. The configuration page displays.
Page 77 / 208
76
CONNECTIONS
05
/ USING NETWORK
2.
Configure the following settings, as needed.
GENERAL
Verify the following information:
•
Status
- displays the connection status of the network.
•
Network
– displays the type of network connection.
•
Connection Type
- displays the type of connection.
•
Physical Address
- displays the physical address of the
network card used for the network.
•
MTU
- specifies the largest packet size permitted for
Internet transmissions:
–
Automatic
- sets the MTU (Maximum Transmission Unit
at 1500)
verizon.com/fios
|
©
2014 Verizon. All Rights Reserved.
Page 78 / 208
–
Automatic by DHCP
- sets the MTU according to the
DHCP connection
–
Manual
- allows you to manually set the MTU to be set.
COAX LINK
To set the Channel:
1.
Select the coax link channel as 1 to 3.
2.
Select the
On
or
Off
radio button in the
Auto Detection
field.
3.
To set privacy, select the
Enabled
check box. This causes
all devices connected to the coaxial cable to use the same
password. This is recommended.
4.
To set the password, enter the Coax Link password in the
Password
field.
5.
To enable or disable the Coax link, click
Disable
or
Enable
.
6.
To view the devices connected using the coaxial cable, click
the
Go to WAN Coax Stats
link.
COMPLETE ALL ETHERNET/COAX CONNECTION
CONFIGURATION UPDATES
ETHERNET/COAX
CONNECTION
Page 79 / 208
78
CONNECTIONS
05
/ USING NETWORK
To save your changes:
1.
Click Apply.
5.3/
WIRELESS ACCESS POINT CONNECTION
A Wireless Access Point network connection allows wireless devices
to connect to the local area network (LAN) using the 2.4 GHz or 5 GHz
Wi-Fi network.
Note:
Once disabled, all wireless devices connected to that wireless network
will be disconnected from the LAN network and Internet.
To view the connection:
1.
In the Network Connections page, click
Advanced
.
verizon.com/fios
|
©
2014 Verizon. All Rights Reserved.
Page 80 / 208
2.
Click
5 GHz Wireless Access Point 1
or
2.4 GHz Wireless
Access Point 2
.
3.
To disable the connection, click
Disable
.
4.
To rename the connection, enter a name in the
Name
field.
5.
Click
Apply
to save the changes.
6.
Reboot your Gateway.
5.3a/
CONFIGURING WIRELESS ACCESS POINT PROPERTIES
To configure the connection:
WIRELESS ACCESS
POINT CONNECTION
19216811.live