Page 6 / 11
Scroll up to view Page 1 - 5
English
4
3. Configure the Modem
Note: It is recommended that you configure the Modem from a wired computer.
2.
Enter User name and Password,
and then click
OK
. By default,
User name:
admin
Password:
password
1.
Open your web browser, type
in the
Address bar, and press
Enter
.
3.
Click
Setup
Wizard
.
Page 7 / 11
English
5
5.
Select Auto-detect, and then click
Next.
Note: In the example, the DSL connection is PPPoE.
4.
Click
Next
.
6.
Wait for the Auto Detection process
to complete.
Page 8 / 11
Note: If the Setup Wizard could not automatically detect your Internet
connection, select
Manual Selection
and input the information using the
information provided by your ISP.
Note: For other connection methods, follow the on screen instructions after the
Auto Detection.
7.
Configure the settings based on
information provided by your ISP.
Then click
Next
.
9.
Verify that the ADSL LED is lit and
then click
Close
.
Your installation is now complete.
For detailed information regarding the TW100-BRM504's configuration and
advanced settings, please refer to the Troubleshooting section, User's Guide
English
6
8.
Check
Test Internet Connection
,
and then click
Finish
.
Page 9 / 11
7
Troubleshooting
Q1:
A1:
message says “The page cannot be displayed.” How can I get into the
TW100-BRM504's web configuration page?
First, check your hardware settings again by following the instructions in Section 2.
Second, make sure the LAN and WLAN lights are lit.
Third, make sure your TCP/IP settings
are set to
Obtain an IP address automatically
(see the steps below).
1.
Go into the
Control Panel
and double-click
the
Network Connections
icon, right-click
the
Local Area Connection
icon and then
click
Properties
.
2.
Click
Internet Protocol (TCP/IP)
and then
click
Properties
.
Then click on
Obtain an
IP address automatically.
Fourth, press on the factory reset button for 15 seconds.
The Modem does not auto-detect my DSL connection.
What should I do?
First, verify that your DSL account is activated.
Second, make sure all the cables are
properly connected (see Section 2).
Third, in Section 3, select manual selection in the Setup
Wizard and configure the Modem based on information provided by your ISP.
Q2:
A2:
Page 10 / 11
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may
cause undesired operation.
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.
ADVERTENCIA
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de
alimentacón necesario para su funcionamiento.
El uso de un adaptador distinto al
mencionado puede producir daños fisicos y/o daños al equipo conectado.
El adaptador
de alimentación debe operar con voltaje y frecuencia de la energia electrica domiciliaria
existente en el pais o zona de instalación.
19216811.live