Page 6 / 13
Scroll up to view Page 1 - 5
English
4
3. Configure the Internet Camera
Note:
1. It is recommended that you configure the Internet Camera from a wired
computer.
2. If you would like to use SecurView software, please refer to the User's Guide
on the CD for more information.
2.
Follow the
IPSetup Setup Wizard
instructions and then click
Next
.
3.
Click
Close
.
4.
Go to
Start -> Programs ->
TRENDnet -> IPSetup
and click
IPSetup
.
1.
Insert the Utility CD-ROM into your
CD-ROM drive and then click
IP
Setup
.
Downloaded from
www.Manualslib.com
manuals search engine
Page 7 / 13
English
5
5.
Select the camera server and click
Change IP
.
6.
Configure the desired IP address
to be in the same subnet as your
network, type in the
Administrator
ID
and
Password
and click
Change
.
By default:
ID:
admin
Password:
admin
7.
Click
OK
and wait 30 seconds.
8.
Click
OK
.
Note:
By default, the IP setting on the TV-IP422/TV-IP422W is set to DHCP.
Please skip to step 9.
If you want to give the TV-IP422/TV-IP422W static IP
address, continue on to step 5.
Downloaded from
www.Manualslib.com
manuals search engine
Page 8 / 13
11.
Right click and select
Install
ActiveX Control
.
12.
Click
Install
.
English
6
10.
Enter the User name and
Password, and then click
OK
.
By default:
User Name:
admin
Password:
admin
Note
: If you have the TV-IP422W, continue on to step 13.
If you have the
TV-IP422, skip to step 16.
9.
Double click the camera server to
access the browser configuration.
Downloaded from
www.Manualslib.com
manuals search engine
Page 9 / 13
15.
Disconnect the RJ-45 cable and
unplug the power.
Then plug the
power back in (TV-IP422W).
English
7
14.
Click
Site Survey
.
Select your
wireless network. If encryption
is enabled, select the proper
Authentication
type, enter the
Pre-Shared Key and then click
apply. (Example shows
WPA2-PSK.
If your wireless
network does not support WPA,
select open or shared instead.
Contact your network
administrator for more
information) (TV-IP422W only).
16.
Verify the Power and Link LEDs
are on.
Note:
The TV-IP422W will not work wirelessly until you disconnect the Ethernet
cable from the back of the camera.
13.
Click
Setup
,
Network
and then
click
Wireless
.
(TV-IP422W only).
Downloaded from
www.Manualslib.com
manuals search engine
Page 10 / 13
17.
Click
Live View.
English
8
Your installation is now complete.
Note
: For detailed information regarding the TV-IP422/
422W configuration
and advanced settings, please refer to the Troubleshooting section, User's Guide
TV-IP
Register Your Product
To ensure the highest level of customer service and support, please take a moment to
register your product Online at:
www.trendnet.com/registe
r
Thank you for choosing TRENDnet
Downloaded from
www.Manualslib.com
manuals search engine
19216811.live