Page 6 / 13
Scroll up to view Page 1 - 5
4
1.
Open Internet Browser Window and enter
(camera's
default IP address)
2.
Click on
System Administration
to access the configuration page.
3.
Enter an IP address, Subnet mask, and Default gateway that corresponds
with your existing network for the camera. Then click on
Save
button to keep
the changes.
English
3. Configure the Internet Camera
Note:
The PC's IP (Example 192.168.0.50) address must correspond
with the Internet Camera's IP address (Default IP:
192.168.0.30) in the
same segment for the two devices to communicate.
Note:
If you need to access the configuration remotely, it is
recommended to enter a static IP address and the Internet DNS IP
address.
Page 7 / 13
5
English
4. Using the Internet Camera Wirelessly
1.
Scroll down in the
System Administration
configuration page until you see
the
Wireless Interface
heading.
2.
Type in the
same SSID
of your wireless Access Point or Router into the
ESSID
field.
Set
Wireless Mode
to
Infrastructure
and make sure that the
channel
is the
same
as your wireless Access Point or Router.
If your
wireless Access Point or Router has WEP encryption enabled, select
Data
encryption
and make sure that the
Auth mode, Key length, Key format,
and
Default key
are the same as your wireless Access Point or Router.
Page 8 / 13
6
English
3.
Scroll down to the bottom of the page and Click
Save
.
4.
Disconnect the CAT5 cable and the power adapter connector from the TV-
IP300W.
5.
Reconnect the power adapter connector to the TV-IP300W.
Allow 5-10
seconds for the TV-IP300W and the wireless Access Point to communicate
wirelessly.
Then type the
IP Address
that you assigned to the TV-IP300W in
your web browser for verification.
Page 9 / 13
7
Q1.
A1.
Q2.
A2.
Q3.
A3.
Q4.
A4.
The image is blurry, how do I fix this?
You can adjust the Internet Camera's focus by rotating the lens.
Can I replace the camera lens?
The Internet Camera's Lens is replaceable with a standard CS-Mount
type lens.
How do I view the Internet Camera's live images within my Local
Network?
Open a web browser (Internet Explorer or Netscape), type your
Wireless Internet Camera's IP address (i.e.:
192.168.0.30) in the Address
bar, and then hit the
Enter
key. The Welcome page of the Internet Camera
will appear.
When I enter the IP address of the camera, the image does not load,
why?
Please make sure all the Active X features are enabled for your
Internet Explorer.
1. Go to
Tool
(on the Tool bar) > Internet options > Security
Troubleshooting
Page 10 / 13
8
2. Click on
Custom Level
and make sure all ActiveX controls are set to
"Enable"
and click
OK
.
3. Once you save the settings, the browser will load again and the image
should appear.
19216811.live