Page 6 / 18 Scroll up to view Page 1 - 5
4
3. Configure the Modem
Note:
It is recommended that you configure the Modem from a wired computer.
1.
Open your web browser, type
in the Address bar, and
then press
Enter
.
2.
Enter the User Name and
password and then click
OK
.
By default:
User name: admin
Password: admin
Note: User name and Password is case
sensitive.
3.
Click
Setup
Wizard
.
Page 7 / 18
5
Note:
1. The example below is for Auto-detect. If the Setup Wizard could not automatically
detect your Internet connection, select
Manual Selection
and input the information
using the information provided by your ISP.
2. In the example below, the ADSL connection is PPPoE
4.
Click
Next
.
5.
Select
Auto-detect
and then click
Next
.
6.
Configure the settings based on information
provided by your ISP. Then click
Next
.
7.
Configure the settings based on information
provided by your ISP. Then click
Next
.
Page 8 / 18
6
Note
: For other connection methods, follow the on screen instructions after you select
auto-detect.
8.
Please wait while the TEW-657BRM reboots.
9.
Check the LEDs and then click
OK.
10.
Check
Test Internet Connection
, and then
click
Finish
.
11.
Verify that the test has completed successfully.
Check that the ADSL and Internet LEDs are lit.
Then click
Close
.
12.
Open up your browser and enter in a URL
(e.g. www.trendnet.com) to verify that you
have Internet connection.
Page 9 / 18
4. Setting up Encryption
7
1.
Click
Wireless
Note
: To protect your network from any unauthorized access it is recommended to
enable wireless encryption.
2.
Select the
Region
, enter the desired
SSID
and
then click
Save
.
3.
Click
Configure SSID1
to set up Wireless
Security.
Page 10 / 18
8
Your Configuration is complete
Register Your Product
To ensure the highest level of customer service and support, please take a moment to
register your product Online at:
www.trendnet.com/registe
r
Thank you for choosing TRENDnet
For detailed information regarding the
TEW-657BRM’s
configuration and advanced settings,
please refer to the Troubleshooting section, User's Guide CD-ROM, or TRENDnet's website
4.
This example below is WPA2-PSK. Select a
Security System
and enter an encryption key
in the
PSK
field.
Keep
the
Encryption
value
as AES, click
Save
and then click
Close.
For
WPA-PSK or WPA2-PSK, the Pre-Shared Key
must be between 8 and 63 ASCII or 64 HEX
characters.
Make sure to copy down the
encryption key.

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top