Page 6 / 21
Scroll up to view Page 1 - 5
4
2. Hardware Installation
Cable/DSL Modem
Internet
1.
Verify that you have an Internet connection
when connecting the 3G USB adapter to your
computer. Open your browser (e.g. Internet
Explorer) and type in a URL (e.g.
Note: You may need to activate your Internet
connection.
Please contact your ISP for more
information.
2.
Remove the battery lid.
The battery lid is
located on the bottom of the router.
4.
Secure the battery lid back into the router.
3.
Insert the battery into the router.
Page 7 / 21
5
7.
If you are using the TEW-655BR3G for the first
time, you will need to charge your battery for 8
hours.
10.
Verify that the following panel lights are on:
Power, Wireless, Ethernet and 3G (USB).
5.
Connect one end of the provided RJ-45 cable
to the TEW-655BR3G's Ethernet port. Connect
the other end of the cable to the computer's
Ethernet port.
6.
Connect the AC Power Adapter to the wireless
router and then to a power outlet.
8.
Connect your 3G USB adapter to the USB port
on the TEW-655BR3G.
9.
Move the Power switch to the on position.
Page 8 / 21
6
3. Configure the TWE-655BR3G
Note:
1. Gather all information related to your Internet Connection before you start.
If necessary, contact your Internet Service Provider (ISP).
2. Below are steps for connecting to a 3G Internet connection. For instructions
connecting to a Broadband Internet connection, please see question 5 in the
Troubleshooting section.
1.
Open your web browser, type
in the Address bar, and
then press
Enter
.
3.
Select
Wizard
and then click
Enter
.
4.
Click
Next
.
2.
Enter the System Password, and then click
Login
.
By default:
System Password:
admin
Page 9 / 21
7
Note:
1. To protect your network from any unauthorized access it is recommended to enable
wireless encryption.
2.
The example below is for WPA2-PSK security. If you select WPA-PSK or WPA2-PSK,
make sure your wireless adapters support WPA or WPA2. If your wireless adapters
do not support WPA or WPA2, then select WEP.
5.
Enter the Old password (By default, the
Password
is
admin
), enter a
New
Password
,
reconfirm the
New Password
and then click
Next
.
6.
Select your Time Zone and then click
Next
.
7.
Select
Wireless WAN
for WAN Interface.
Select 3G or iBurst (the example shown is for
3G). Then click
Next
. Configure the settings
based on information provided by your ISP.
Follow the wizard instructions to complete the
configuration.
Note: Each WAN type may have different
options.
8.
Enter the desired
Network ID
(
SSID)
and then
click
Next
.
Page 10 / 21
8
9.
Select the desired
Authentication
mode,
select the desired Encryption type and enter
characters for your Pre-Shared key and then
click
Next
. For WPA-PSK or WPA2-PSK, the
Pre-Shared Key must be between 8 and 63
ASCII or 64 HEX characters. Make sure to
copy down the Pre-Shared Key.
10.
Check
Do you want to proceed with
network testing?
and then click
Apply
Settings.
11.
Wait around 43 seconds while the router
reboots.
12.
Wait around 15 seconds while the router tests
the Internet connection.
13.
Click
Finish
.
19216811.live