Page 6 / 17
Scroll up to view Page 1 - 5
4
9
. Enter a password and then click
Login
.
The
default password is
admin
.
10.
Select
Access Point
and then click
Next
.
Note: For AP Client setup, please refer to the
User's Guide for step by step instructions.
The User's Guide can be found on this
product's CD-ROM.
11.
Select
Dynamic IP Address Configuration
and then click
Configure
.
12.
Select
Manual setup
and then click
Next
.
Page 7 / 17
5
13
. Enter a SSID and then click
Next
.
By default,
the SSID is
TRENDnet638PAP
.
14.
Select the desired
Wireless Mode
and then
click
Next
.
15.
Select a
Security Mode
and then click
Next
(example shows WPA-PSK).
16.
Select the desired
WPA
mode, enter
characters for your Pre-Shared key and then
click
Next
.
For WPA-PSK or WPA2-PSK, the
Pre-Shared Key must be between 8 and 63
ASCII or 64 HEX characters.
Make sure to
copy down the Pre-Shared Key.
Page 8 / 17
6
17
. Click
Save
(optional).
18.
Give the file a name, then click
Save
(optional).
19.
Click
Configure
to apply the settings.
20.
Click
Exit
.
Page 9 / 17
7
Note
: to connect a wireless computer to the TEW-638PAP, please refer to the first
question in the troubleshooting section.
Your Installation is complete
Register Your Product
To ensure the highest level of customer service and support, please take a moment to
register your product Online at:
www.trendnet.com/registe
r
Thank you for choosing TRENDnet
For detailed information regarding the
TEW-638PAP
’s
configuration and advanced settings,
please refer to the Troubleshooting section, User's Guide on the Utility CD-ROM, or
21
. Click
Yes
to exit.
22.
Connect the 2dBi detachable antennas to the
TEW-638PAP.
Page 10 / 17
8
3. Power-over-Ethernet Installation
Using the TEW-638PAP with a PoE switch
1
. Connect a RJ-45 cable from the Power-Over-
Ethernet Switch (e.g. TRENDnet TPE-80WS) to
the
LAN
port on the Access Point.
2.
Verify that the wireless, LAN, and power LEDs
are on.
19216811.live