7
Troubleshooting
Q1:
A1:
Q2:
A2:
Q3.
A3:
Q4.
A4:
address bar, but error message says "The page cannot be displayed". How can I
get into the TEW-610APB's web configuration page?
Please check your hardware and TCP/IP settings again by following the
instructions
sections 1~3, make sure the Power, LAN, MIMO on the Access
Point's front panel are on and the TCP/IP configurations are correct. then try
If my network's IP is different than the Access Point's range, what should I
do?
You should still configure the access point first. After all the settings are applied,
go to the Access Point's configuration page, click on TCP/IP settings and change an
IP address for the Access Point to match your network's IP.
After I successfully configured the Access Point to meet my network settings,
I cannot connecting to my network using wireless computers.
If you have a DHCP server in your network, you need to go into TCP/IP
settings again and re-select "Obtain an IP automatically" for
Windows 98/ME and
"Obtain an IP Address automatically" for Windows 2000/XP to allow the PC to
regain an IP address from your DHCP server.
All the settings are set correctly, but I still can't use the Access Point, what
should I do?
You can find additional information in the User's Guide. If you still have
Problems,
contact our Technical Support by email or phone.
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received.
Including interference that may cause undesired operation.
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
19216811.live