Page 6 / 17
Scroll up to view Page 1 - 5
ENGLISH
FRANÇAIS
DEUTSCH
ESPAÑOL
ÐÓÑÑÊÈÉ
4
8.
Crimp the stripped cable to the RJ-45 plug.
7.
Insert the wires on the stripped end of the cable
into the RJ-45 plug. Make sure the wires are
inserted into the RJ-45 plug based TIA/EIA
T-568A or T-568B standard.
9.
Insert the gasket to the front end of the
connector.
Then put the screw nut on the back.
10.
Connect the clamp ring and sealing nut to the
PoE
port on the rear of the TEW-455APBO.
Hold the assembly firmly and tighten by hand.
Page 7 / 17
ENGLISH
FRANÇAIS
DEUTSCH
ESPAÑOL
ÐÓÑÑÊÈÉ
5
15.
Connect the power cord into the Power over
Ethernet adapter.
Then connect the power
cord into a power outlet.
14.
Connect the opposite end of the Ethernet
cable to a LAN port on your network.
12.
Connect the opposite end of the Ethernet
cable to the
LAN + DC
port on the Power over
Ethernet Adapter.
13.
Connect one end of another Ethernet cable to
the
LAN
port.
11.
Wrap the waterproof RJ45 tightly with the
waterproof tap for double protection from
water. (The wrapped area of the RJ45 should
cover from enclosure to cable.)
Incorrect
Correct
Incorrect
16.
Verify that the following panel LEDs are on:
Power
and
WLAN
.
Page 8 / 17
ENGLISH
FRANÇAIS
DEUTSCH
ESPAÑOL
ÐÓÑÑÊÈÉ
6
3. Mounting
Wall Mounting
1.
Align the mounting bracket with the holes on
the bottom of the unit and secure it with the
screws and washers provided.
2.
Use the wall bracket as a template and mark
the wall for the correct screw / fastener
position.
3.
Drill holes for the fastener plugs at the marked
positions on the wall.
4.
Insert fastener plugs into the drilled holes.
5.
Use the provided wood screws to screw the
outdoor unit/swivel mounting bracket to the
fastener plugs to the wall.
Page 9 / 17
ENGLISH
FRANÇAIS
DEUTSCH
ESPAÑOL
ÐÓÑÑÊÈÉ
7
Pole Mounting
6.
Insert the mounting bracket into the wall
mounting bracket and secure with the washers
and screws provided.
7.
Adjust the orientation of the antenna as
necessary.
8.
Once the unit is positioned correctly, tighten all
screws.
1.
Align the mounting bracket with the holes on
the bottom of the unit and secure it with the
screws and washers provided.
2.
Slide the two provided u-clamps around the
pole. Place the pole mounting bracket at the
desire height and position.
Page 10 / 17
ENGLISH
FRANÇAIS
DEUTSCH
ESPAÑOL
ÐÓÑÑÊÈÉ
8
3.
Secure the mounting bracket to the pole
mounting bracket using the nuts and washers
provided.
4.
Adjust the orientation of the antenna as
necessary.
5.
Once the unit is positioned correctly, tighten all
screws.
19216811.live