Q1.
A1.
Q2.
A2.
Q3.
A3.
I specified the IP address,
192.168.0.1 in my internet browser, but an error message says
"The page cannot be displayed". How can I get into the TEW-431BRP web configuration
page?
Please check your hardware and TCP/IP settings again by following the instructions in
section 1-3, make sure the Power, WAN, and on the LAN lights on the Router's front panel
are on, and verify that the TCP/IP configurations is correct.
Then try accessing to the
192.168.0.1 again using your web browser.
I am not sure what type of Internet Account Type I have for my Cable/DSL modem, How
do I find out?
You can simply contact your Internet Service Provider's (ISP) Customer Service or
Technical Support Department for the correct information.
I set up my internet connection type and saved it, but I still cannot connect to the
Internet. Why?
Option 1: Please go to the Status section of the configuration page, and click on
Connection Detail button. Click on the Release/Renew button to allow the router to refresh
again with your Internet browser. Option 2: Please power down all the equipments including
Cable/DSL modem, Router and your PC. Power on the Cable/DSL modem and wait 60
seconds, then power on the router followed by your PC. This simple
power cycle normally
helps the router to find your Internet connection. Then try browsing a website such as
Technical Support Hours
7:00AM ~ 6:00PM, Monday through Friday
Pacific Standard Time (except holidays)
Contact Technical Support
Telephone: +1-310-626-6252
Fax:
+1-310-626-6267
Website:
www.TRENDNET.com
E-mail:
Troubleshooting
Note:
For more detailed information about TEW-431BRP's configuration and advanced
settings, please refer to the User's Guide on the CD-ROM.
If you still encounter problems setting up the router, we can help. Please have your Internet
account information ready, (ISP, Account Type) and contact us using the information below.
Certifications
This equipment has been tested and found to comply with
FCC and CE Rules.
Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Downloaded from
www.Manualslib.com
manuals search engine
19216811.live