TD-W8151N

150Mbps Wireless N ADSL2+ Modem Router User Guide

9

Figure 3-2

Step 3:

Select

General

tab, highlight Internet Protocol (TCP/IP), and then click the

Properties

button.

Figure 3-3

TD-W8151N

150Mbps Wireless N ADSL2+ Modem Router User Guide

10

Step 4:

Configure the IP address as Figure 3-4 shows. After that, click

OK

.

Figure 3-4

)

Note:

You can configure the PC to get an IP address automatically, select “Obtain an IP address

automatically” and “Obtain DNS server address automatically” in the screen above.

Now, you can run the Ping command in the command prompt to verify the network connection.

Please click the

Start

menu on your desktop, select

run

tab, type

cmd or command

in the field

and press

Enter

. Type

ping 192.168.1.1

on the next screen, and then press

Enter

.

If the result displayed is similar to the screen below, the connection between your PC and the

Router has been established.

Figure 3-5

If the result displayed is similar to the screen shown below, it means that your PC has not

connected to the Router.

TD-W8151N

150Mbps Wireless N ADSL2+ Modem Router User Guide

11

Figure 3-6

You can check it follow the steps below:

1)

Is the connection between your PC and the Router correct?

The LEDs of LAN port which you link to the device and the LEDs on your PC's adapter should

be lit.

2)

Is the TCP/IP configuration for your PC correct?

If the Router's IP address is 192.168.1.1, your PC's IP address must be within the range of

192.168.1.2 ~ 192.168.1.254.

3.2

Login

Once your host PC is properly configured, please proceed as follows to use the Web-based Utility:

Start your web browser and type the private IP address of the Router in the address field:

.

After that, you will see the screen shown below. Enter the default User name

admin

and the

default Password

admin

,

and then click

OK

to access to the

Quick Setup

screen. You can follow

the steps below to complete the Quick Setup.

TD-W8151N

150Mbps Wireless N ADSL2+ Modem Router User Guide

12

Figure 3-7

Step 1:

Select the

Quick Start

tab, then click

RUN WIZARD

, and you will see the next screen.

Click the

NEXT

button.

Figure 3-8

Step 2:

Configure the time for the Router, and then click the

NEXT

button.

Figure 3-9

Step 3:

Select the connection type to connect to the ISP (We select

PPPoE/PPPoA

mode for

example here), and then click the

NEXT

button.

TD-W8151N

150Mbps Wireless N ADSL2+ Modem Router User Guide

13

Figure 3-10

Step 4:

Configure the following options provided by your ISP:

Username

,

Password

,

VPI

,

VCI

and

Connection Type

. Then click

Next

.

Figure 3-11

Step 5:

Configure the rules for the WLAN, and click

NEXT

.