TD-8811

ADSL2+ Modem Router User Guide

56

Figure 4-33

To add a new entry, follow the steps below.

1.

Click the

Add

button in Figure 4-33 to go to the

Static Route Add

page as shown in Figure

4-34.

2.

Enter the IP address of the destination network. This parameter specifies the IP network

address of the final destination.

3.

Enter the Subnet Mask for the destination.

4.

Select the

Use Gateway IP Address

checkbox and enter the IP address of the gateway.

The gateway is an immediate neighbor of your ADSL Router that will forward the packet to

the destination. On the LAN, the gateway must be a router on the same segment as your

Router; over Internet (WAN), the gateway must be the IP address of one of the remote

nodes.

5.

Click

Save/Apply

to save your configurations. Then you will go back to Figure 4-33 and

see your new entry.

Figure 4-34

4.3.6 DSL

Choose “

Advanced Setup

→

DSL

” menu, you can view and configure the parameters in the

screen as shown in Figure 4-35.

TD-8811

ADSL2+ Modem Router User Guide

57

Figure 4-35

If you want to make some advanced settings, click

Advanced Settings

button in Figure 4-35 to

go to the

DSL Advanced Settings

page as shown in Figure 4-36.

Figure 4-36

If you want to select the tone, click the

Tone Selection

button to go to the ADSL Tone Settings

page as shown in Figure 4-37.

TD-8811

ADSL2+ Modem Router User Guide

58

Figure 4-37

4.4

Diagnostics

Choose “

Diagnostics

”, and your modem will test your DSL connection. Then you will see the

test results for the connectivity to your local network and your DSL service provider similar to

Figure 4-38.

TD-8811

ADSL2+ Modem Router User Guide

59

Figure 4-38

4.5

Management

Choose “

Management

”, and you can see the submenus as shown in Figure 4-39.

Figure 4-39

4.5.1 Settings

Choose “

Management

→

Settings

” menu, and you will see the submenus as shown in Figure

4-40.

Figure 4-40

TD-8811

ADSL2+ Modem Router User Guide

60

4.5.1.1 Backup

Choose “

Settings

→

Backup

” menu, and you can save the current configuration of the Router

as a backup file in Figure 4-41. Click

Backup Settings

button to save your current

configuration.

Figure 4-41

4.5.1.2 Update

Choose “

Settings

→

Update

” menu, and you can update the settings for the Router as shown in

Figure 4-42. Click the

Browse…

button to find the file you want to update and then click

Update

Settings

to begin the updating.

Figure 4-42