Page 26 / 125
Scroll up to view Page 21 - 25
Archer
D9
AC1900 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
Chapter 4. Configuring the Modem Router
This chapter will show configuration for the key functions on the Web-based management page.
4.1 Login
After your successful login, you will see the twenty-three main menus on the left of the Web-based
utility. On the right, there are the corresponding explanations and instructions.
The detailed explanations for each Web page’s key function are listed below.
15
Page 27 / 125
Archer
D9
AC1900 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
4.2 Status
Choose “
Status
”, you can see the corresponding information about
Device Information
,
DSL
,
WAN
,
LAN
and
Wireless
.
16
Page 28 / 125
Archer
D9
AC1900 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
Figure 4-1
17
Page 29 / 125
Archer
D9
AC1900 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
4.3 Quick Setup
Please refer to
3.2 Quick Installation Guide
.
4.4 Operation Mode
Choose “
Operation Mode
”, and you will see the screen as shown in Figure 4-2. Select your
desired mode and then click
Save
.
Figure 4-2
DSL Modem Router Mode:
The device enables multi-users to share Internet via ADSL using
its ADSL port and share it wirelessly at 1300Mbps wireless speeds over the crystal clear 5GHz
band and 600Mbps over the 2.4GHz band.
Wireless Router Mode:
The device enables multi-users to share Internet via Ethernet WAN
(EWAN) using its interchangeable LAN4/WAN port and share it wirelessly at 1300Mbps
wireless speeds over the crystal clear 5GHz band and 600Mbps over the 2.4GHz band.
After you click the
Save
button, the Note Dialog will appear. Click
OK
and then the modem router
will reboot. Please wait.
Note Dialog
4.5 Network
Choose “
Network
”, there are many submenus under the main menu. Click any one of them, and
you will be able to configure the corresponding function.
18
Page 30 / 125
Archer
D9
AC1900 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
4.5.1
WAN Settings
Choose “
Network
”
“
WAN Settings
”, and you will see the WAN Port Information Table in the
screen similar to Figure 4-3. There are six different configurations for the connection types, which
are Static IP, Dynamic IP, PPPoE, PPPoA, IPoA and Bridge. You can select the corresponding
types according to your needs.
Figure 4-3
Click
Add
to add a new entry, you can configure the parameters for ATM and WAN Service in the
next screen (shown in Figure 4-4).
19
19216811.live