Page 86 / 90 Scroll up to view Page 81 - 85
E-DOC-CTC-20090619-0001 v1.0
80
9
Troubleshooting
9.5
Voice over IP Troubleshooting
Introduction
If you cannot make or receive any phone calls via your Thomson Gateway, try the suggestions in the
following sections.
Calling over VoIP
If you have problems calling via VoIP, check whether:
±
Your phone is correctly connected to the Thomson Gateway.
±
Your phone is working on the traditional telephone network (PSTN):
²
Connect your phone directly to the telephone wall outlet.
²
Try to make a phone call.
±
Your phone number, user name, and password are configured correctly.
±
The registrar’s and proxy server’s IP address and port number are configured correctly.
±
The
Power
,
Broadband/DSL
and
Voice
LEDs are on.
Calling over the traditional telephone network (PSTN)
If you have problems calling via the traditional telephone network, check whether:
±
Your phone is correctly connected to the Thomson Gateway.
±
Your phone is working on the PSTN network:
²
Connect your phone directly to PSTN.
²
Try to make a phone call.
±
The Forced FXO service is activated, this means that your service provider may request you to dial an
extra prefix for making calls via PSTN.
Problems with Telephony Services
If you have a problem with a service, check whether the service is activated. For more information, see
“4.3.2 Activating a Telephony Service on your Thomson Gateway” on page 40
.
If the Thomson Gateway is turned off, phone calls are always routed over PSTN.
Page 87 / 90
E-DOC-CTC-20090619-0001 v1.0
81
9
Troubleshooting
9.6
Reset to Factory Defaults
Resetting your Thomson Gateway
If at some point you can no longer connect to the Thomson Gateway or you want to make a fresh install, it
may be useful to perform a reset to factory defaults.
Warning
A reset to factory default settings deletes all configuration changes you made. Therefore, after the reset, a
reconfiguration of your Thomson Gateway will be needed.
Also your wireless clients will have to be re-associated, as described in
“3 Wireless Access” on page 23
.
Methods
You can choose between:
±
Resetting the Thomson Gateway via the Thomson Gateway GUI
±
Reset the Thomson Gateway via the Reset button
Resetting the Thomson Gateway via the Thomson Gateway GUI
Proceed as follows:
1
Browse to the
Thomson Gateway GUI
.
2
On the
Thomson Gateway
menu, click
Configuration
.
3
In the
Pick a task
list, click
Reset my
Thomson Gateway.
4
The Thomson Gateway restores the initial configuration and restarts.
5
The Thomson Gateway returns to the Thomson Gateway home page (unless the IP address of your
computer is not in the same subnet as the default IP address of the Thomson Gateway, being
192.168.1.254).
Page 88 / 90
E-DOC-CTC-20090619-0001 v1.0
82
9
Troubleshooting
Reset the Thomson Gateway via the Reset button
Proceed as follows:
1
Make sure the Thomson Gateway is turned on.
2
Push the
Reset
button until the
Power
LED lights red - this will take about 7 seconds.
3
Release the
Reset
button.
4
The Thomson Gateway restarts.
Your system administrator may have disabled the physical reset button of the Thomson
Gateway. In this case, a hardware reset to defaults is not possible.
Page 89 / 90
Page 90 / 90
THOMSON Telecom Belgium
Prins Boudewijnlaan 47
2650 Edegem
Belgium
www.thomson.net
© THOMSON 2010. All rights reserved.
E-DOC-CTC-20090619-0001 v1.0.

Rate

124.8 / 5 based on 304 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top