19216811.liveChapter 6
Troubleshooting
E-DOC-CTC-20050429-0099 v1.0
93
6.3
Reset to Factory Defaults
Resetting your
SpeedTouch™
You might consider a reset to factory defaults as described below.
You can choose between:
±
Hardware reset
±
Software reset
A reset to factory default settings deletes the configuration profile settings.
Therefore, after the reset, a reconfiguration of your SpeedTouch™ will be needed.
Hardware reset
Proceed as follows:
1
Make sure the SpeedTouch™ is powered on.
2
Use a pen or an unfolded paperclip to push the recessed reset button on the
back panel. The reset button is marked with a red circle. Keep it pushed until
the power LED lights red - this will take about 7 seconds.
3
Release the reset button.
4
The SpeedTouch™ restarts.
Software reset
Proceed as follows:
1
Go to the SpeedTouch™ web pages.
2
In the menu select
SpeedTouch > Configuration
.
3
In the
Pick a task...
list, click
Reset my SpeedTouch to default settings
.
4
The SpeedTouch™ restarts.
5
The SpeedTouch™ returns to the SpeedTouch™ Home page (unless the IP
address of your computer is not in the same subnet as the default IP address of
the SpeedTouch™, being 192.168.1.254).
!
Be aware that a reset to factory defaults will revoke all configurational
changes you made to the SpeedTouch™.
DSL
RESET
ON/OFF
ETHERNET
15VAC
USB