Page

56

/

84

7.

5 GHz\Security

This page allows you to configure security of wireless.

Fig. 2-36

Wireless\5 GHz\Security



Wireless security mode:

The wireless security mode can be either WPA Personal or WPA.



Authentication:

The method of authentication can be WPA/WPA2 or WPA.



Passphrase:

You can enter ASCII codes into this field. The range is from 8 characters to 64

characters. For

ASCII characters

, you can key in

63

characters in this field. If you want to key in

64

characters, only

hexadecimal characters

can be used.



Retype Passphrase:

Enter the passphrase again for confirmation.

Page

57

/

84

8.

5 GHz\Advanced

This page allows configuring advance wireless settings.

Fig. 2-37

Wireless\5 GHz\Advanced



Country:

Please select the country code.



Mac Address:

The MAC address for this wireless device will be displayed in this field

automatically.



Beacon Interval:

Set the period of beacon transmissions to allow mobile stations to locate and

identify a BSS. The measure unit is “time units” (TU) of 1024 microseconds. (Value range:

1~65535)



DTIM Interval:

The value you set here is used to inform mobile stations when multicast frames that

have been buffered at the Wireless Voice Gateway will be delivered and how often that delivery

occurs. (Value range: 1~255)



Fragment Threshold:

Set the number of the fragmenting frames to make the data to be delivered

without errors induced by the interference. Frames longer than the value you set here are fragmented

before the initial transmission into fragments no longer than the value of the threshold. (Value range:

256~ 2346)

Page

58

/

84



RTS Threshold:

Set the value for sending a request to the destination. All the frames of a length

greater than the threshold that you set here will be sent with the four-way frame exchange. And, a

length less than or equal to the value that you set will not be proceeded by RTS. (Value range: 0~

2347)



WMM:

Wi-Fi Multimedia (WMM) is a component of the IEEE 802.11e wireless LAN standard for

quality of service (QoS). The QoS assigns priority to the selected network traffic and prevents packet

collisions and delays thus improving VoIP calls and watching video over WLANs. It may help you

to

Enable

or

Disable

the WMM function. To enable you need to select

Enabled

, to disable you need

to select

Disabled

.



WMM Power Save:

This field allows you to enable WMM Power Save-Support. To enable you

need to select

Enabled

, to disable you need to select

Disabled

.

Page

59

/

84

9.

5 GHz\Access Control

This page allows you to configure access control.

Fig.2-38

Wireless\5 GHz\Access Control



Policies:

Policy of access control settings. Two options can be selected. It can be either Allow List

or Deny List.



Mac Address:

The MAC address list that allow of deny access.



Add row:

Click

”

Add row

”

for adding a new row of Mac Address.



Delete:

Check

”

Delete

”

of a raw and click

”

Save

”

button for deleting it.

Page

60

/

84

10.

5 GHz\WPS

This page allows you to configure WPS setting.

Fig. 2-39

Wireless\5 GHz\WPS



WPS:

It will help you to

Enable

or

Disable

the WPS feature. To enable you need to select

WPS

, to

disable you need to select

Disabled

.



PIN:

This is the PIN for authentication. Enter the PIN and the click

“

PIN start

”

for start PIN

connection.



PBC:

Click

“

PBC start

”

for starting it.