Page 21 / 60 Scroll up to view Page 16 - 20
21
10 Configuration Wizard
Click
Wizard
to configure the router. The Setup wizard will now be displayed;
check that the modem is connected and click
Next.
Select your country from the Country list. Select your internet provider. Click
Next.
Depending on the chosen provider, you may need to enter your user name
and password, MAC address or hostname in the following window. After you
have entered the correct information, click
Next
.
Page 22 / 60
22
Click
APPLY
to complete the configuration.
Page 23 / 60
23
11 Wireless Settings
You can set parameters that are used for the wireless stations to connect to
this router. The parameters include Mode, ESSID, Channel Number and
Associated Client.
Wireless Function
Enable or Disable Wireless function here.
Click
Apply
and wait for module to
be ready & loaded.
Page 24 / 60
24
Basic Settings
Mode
Allows you to set the AP to AP, Station, Bridge or WDS mode.
Band
Allows you to set the AP fixed at 802.11b or 802.11g mode. You can
also select B+G mode to allow 80211b and 802.11g clients at the same time.
ESSID
This is the name of the wireless signal which is broadcasted. All the
devices in the same wireless LAN should have the same ESSID.
Channel Number
The channel used by the wireless LAN. All devices in the
same wireless LAN should use the same channel.
WLAN MAC
This is the MAC address used by the Wireless interface of this AP
when it is in the station mode.
Clone MAC
Click the “Clone MAC” button will copy the MAC address of your
PC,
that you are using to configure the AP, to the WLAN MAC.
MAC address
If you want to bridge several networks together through the
wireless connection, you have to set this access point to “AP Bridge-Point to
Point mode”, “AP Bridge-Point to Multi-Point mode” or “AP Bridge-WDS
mode”. You have to enter the MAC addresses of the other access points
Page 25 / 60
25
Advanced Settings
This tab allows you to set the advanced wireless options. The options included
are Authentication Type, Fragment Threshold, RTS Threshold, Beacon
Interval, and Preamble Type. You should not change these parameters unless
you know what effect the changes will have on the router.
Authentication Type
There are two authentication types: "Open System"
and "Shared Key". When you select "Open System", wireless stations can
associate with this wireless router without WEP encryption. When you
select "Shared Key", you should also setup a WEP key in the "Encryption"
page. After this has been done, make sure the wireless clients that you
want to connect to the device are also setup with the same encryption
key.
Fragment Threshold
"Fragment Threshold" specifies the maximum size
of a packet during the fragmentation of data to be transmitted. If you set
this value too low, it will result in bad performance.
RTS Threshold
When the packet size is smaller then the RTS threshold,
the wireless router will not use the RTS/CTS mechanism to send this
packet.
Beacon Interval
is the interval of time that this wireless router
broadcasts a beacon. A Beacon is used to synchronize the wireless
network.

Rate

3.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top