Page 11 / 60 Scroll up to view Page 6 - 10
11
Select [Internet Protocol (TCP/IP)] =>Click [Properties].
Select the [General] tab.
a. WL-303/WL-306/WL-312 supports [DHCP] function, please select both
[Obtain an IP address automatically] and [Obtain DNS server address
automatically].
Page 12 / 60
12
8 Bring up WL-303/WL-306/WL-312
Connect the supplied power-adapter to the power inlet port and connect it to
a wall outlet. TheWL-303/WL-306/WL-312 automatically enters the self-test
phase. During self-test phase, the Power LED will blink briefly, and then will
be lit continuously to indicate that this product is in normal operation.
9
Initial Setup WL-303/WL-306/WL-312
LOGIN procedure
2.
Click OPEN your browser (e.g. Internet Explorer).
3. Type
in address bar and press [Enter]
Page 13 / 60
13
4.
Type user name and password (default is admin/admin).
5. Click
OK
.
6.
You will see the home page of the WL-303/WL-306/WL-312.
The System status section allows you to monitor the current status of your router
the UP time, hardware information, serial number as well as firmware version
information is displayed here.
Page 14 / 60
14
LAN settings
The LAN tabs gives you the opertunity to change the IP settings of the WL-
303/312.
Click
<Apply>
at the bottom of this screen to save any changes.
IP address
192.168.0.1. It is the router’s LAN IP address (Your LAN clients default
gateway IP address).
IP Subnet Mask
255.255.255.0 Specify a Subnet Mask for your LAN segment.
802.1d Spanning Tree
is Disabled by default. If the 802.1d Spanning Tree
function is enabled, this router will use the spanning tree protocol to prevent
network loops.
DHCP Server
Enabled by default. You can enable or disable the DHCP server.
When DHCP is disabled no ip-addresses are assigned to clients and you have to
use static ip-addresses. When DHCP server is enabled your computers will be
assigned an ip-address automatically until the lease time expires.
Page 15 / 60
15
Lease Time
Forever. In the Lease Time setting you can specify the time period
that the DHCP lends an IP address to your LAN clients. The DHCP will change
your LAN client’s IP address when this time threshold period is reached.
IP Address Pool
You can select a particular IP address range for your DHCP
server to issue IP addresses to your LAN Clients.
Note
:
default IP range 192.168.0.100
°
192.168.0.199. If you want your PC(s) to have a
static/fixed IP address, then you’ll have to choose an IP address outside this IP address Pool
Domain Name
You can specify a Domain Name for your LAN. Or just keep the
default (sitecom_router).

Rate

3.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top