Page 6 / 36 Scroll up to view Page 1 - 5
6
Section Two - Connect
the Modem/Router
2.1
This Package contents
1. One ADSL Router modem
2. One RJ-45 straight cable
3. One RJ-11 telephone cable
4. One USB cable
5. 9/12V
Power Adaptor
6. User's Manual &
CD
For any missing items,
Please
contact
your
dealer immediately.
Section Two: Connect the Modem/Router
5
6
1.
2
3
4
Page 7 / 36
7
2.2 Product View
Section Two: Connect the Modem/Router
POWER LED
LAN LED
TX/RX
LED
Power Switch
Power Connector
USB Connector
RJ45 LAN Jack
LINK LED
RJ11 Line Jack
Reset Button
(Set to factory Default)
Page 8 / 36
8
Section Two: Connect the Modem/Router
2.3
Hardware Installation
The following steps instruct you to install the Hurricane 9000 for
one computer. For more than one computer, please refer to 2.4
Network Connection.
1. Plug the end of the Ethernet cable into the LAN Jack of the Hurricane
9000.
2. Plug the other end of the Ethernet cable into your computer’s RJ45
Jack of Ethernet card.
3. Connect the Power adaptor to the Power Connector.
4. Plug the telephone cable into the Line Jack .
5. Plug the other end of the telephone cable into
i) a Main Socket .
ii)
OR
the Jack
of the two-way Microfilter labeled
DSL.
2-way
Power Adaptor
RJ-45
USB Cable
(Optional)
OR
Telephone
Computer
Main Socket
ADSL Line
Microfilter
Page 9 / 36
9
Section Two: Connect the Modem/Router
2.4.2 for more than one PC
2.4 Network Connections
2.4.1 for One PC
......
ADSL
RJ-11
ADSL
RJ-45
HUB/Switch
or USB Cable
2.5 LED Indicators
The ADSL Router modem features LED indicators on the front panel that
report modem status:
POWER
Red
Power Light / Steady when power is on.
LINK
Green
WAN
Link
/ Steady during ADSL line status is
showtime.
TX/RX
Green
WAN Activity / Blinking when transmitting/receiving
data.
LAN
Green
LAN
Link / Blinking during
LAN Activity.
RJ-11
RJ-45
Page 10 / 36
10
Section Three -
Configure the PCs
3.1 Configure your PC.
The instructions in this section will help you to configure each
computer to communicate with the Router.
To do this, you need to configure your PC’s network settings to
obtain an IP address automatically from the DHCP of the router.
Computers use IP addresses to communicate with each other
across a network, such as the Internet.
For Windows 98/ME
1. Go to the Network screen by clicking the
Start
button. Click
Settings
and then
Control Panel
. From there, double-click the
Network
icon.
2. On the Configuration tab, select the TCP/IP line for the
applicable Ethernet adapter. Then, click the Properties button.
3. Click the
IP Address
tab. Select
Obtain an IP
address automatically
.
4. Click the
Gateway
tab,
and verify that the
Installed Gateway field
is blank. Click the OK
button.
5. Click the
OK
button
again.
Click the Yes
button to restart your
computer.
Section There: Configure the PCs

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top