Page 56 / 68
Scroll up to view Page 51 - 55
PROLiNK
®
H5004N User Manual
www.prolink2u.com
Version 1.00 (Jan’10)
55
4.8
Statistics
The DSL device shows the different layer of network statistics information.
4.8.1
Interfaces
You can view statistics on the processing of IP packets on the networking interfaces. You
will not typically need to view this data, but you may find it helpful when working with your
ISP to diagnose network and Internet data transmission problems.
To display updated statistics showing any new data since you opened this page, click
Refresh.
Page 57 / 68
PROLiNK
®
H5004N User Manual
www.prolink2u.com
Version 1.00 (Jan’10)
56
4.8.2
ADSL
This page shows the ADSL line statistic information.
Page 58 / 68
PROLiNK
®
H5004N User Manual
www.prolink2u.com
Version 1.00 (Jan’10)
57
Chapter 5
Channel Mode Configuration
ADSL router supports multiple channel operation modes. This section will show procedures to configure
the router.
5.1
Bridge Mode
ADSL modem/router can be set to Bridge mode.
1.
Open the WEB page at “WAN interface/Channel Configuration”.
2.
Select your VPI/VCI under ATM VC table
3.
Change the Channel Mode to “1483 Bridged”. Set the parameters VPI/VCI and
Encapsulation mode according to the CO DSLAM’s setting.
4.
Click “Add” button to add this channel into VC table.
5.
Open the WEB page at “Admin/ Commit/Reboot”. Press “Commit” to save the settings into
flash memory.
6.
The new settings will take effect after reboot the system.
Page 59 / 68
PROLiNK
®
H5004N User Manual
www.prolink2u.com
Version 1.00 (Jan’10)
58
5.2
MER (Mac Encapsulating Routing) Mode
1.
Open the WEB page at “WAN interface/Channel Configuration”.
2.
Select the Channel Mode to “1483 MER”. Set the parameters VPI/VCI and Encapsulation
mode according to the CO DSLAM’s setting.
3.
Set “Local IP Address:” according to the IP that ISP assign for your router. Set “Remote IP
Address” to the ISP’s gateway.
4.
Click “Add” button to add this channel into VC table.
5.
Open the WEB page at “Admin/ Commit/Reboot”. Press “Commit” to save the settings into
flash memory.
6.
The new settings will take effect after reboot the system.
Page 60 / 68
PROLiNK
®
H5004N User Manual
www.prolink2u.com
Version 1.00 (Jan’10)
59
5.3
PPPoE Mode
1.
Open the WEB page at “WAN interface/Channel Configuration”.
2.
Select the Channel Mode to “PPPoE”. Set the parameters VPI/VCI and Encapsulation mode
according to the CO DSLAM’s setting.
3.
Enter user/password from your ISP.
4.
Click “Add” button to add this channel.
5.
Enable DHCP server to allow the local PCs share the PPP connection. Reference to section
4.6.1 DHCP Server Configuration.
6.
Set DNS address from your ISP. Reference to section 4.6.2 DNS Configuration.
7.
Open the WEB page at “Admin/ Commit/Reboot”. Press “Commit” to save the settings into
flash memory.
8.
The new settings will take effect after reboot the system.
19216811.live