Page 91 / 101
Scroll up to view Page 86 - 90
Field
Description
Web Idle Time Out
Set the time after which the system automatically exits
the configuration page. Its value range is 5
—
30
minutes.
Click
Apply
to apply the settings.
3.4.3.2 Services
In the
ACCESS CONTROLS
page, click
Services
. The page as shown in the
following figure appears:
In this page, you can enable or disable the services that are used by the remote
host. For example, if telnet service is enabled at port 23, the remote host can
access the device by telnet through port 23.
Select the management services that you want to enable or disable at the LAN or
WAN interface and click
Apply
to apply the settings.
Caution:
If you disable the HTTP service, you cannot access the configuration
page of the device any more.
85
Page 92 / 101
3.4.3.3 IP Address
In the
ACCESS CONTROLS
page, click
IP Address
. The page as shown in the
following figure appears:
In this page, you can configure the IP address in the access control list (ACL). If
ACL is enabled, only devices of the specified IP addresses can access the
device.
Select
Enable Access Control Mode
to
enable ACL.
Note:
If you enable ACL, ensure that the IP address of the host is in the ACL list
.
Click
Add
. The page as shown in the following figure appears:
Enter the IP address of the desired device in the
IP Address
field and click
Apply
to apply the settings.
86
Page 93 / 101
3.4.4
Diagnostics
Choose
Management
>
Diagnosis
. The page as shown in the following figure
appears:
In this page, you can test the connection status of the device. Click
Return
Diagnostic Test
to run diagnostics. The page as shown in the following figure
appears:
3.4.5
Log Configuration
Choose
Management
>
Log Configuration
. The
SYSTEM LOG
page as shown
in the following figure appears:
87
Page 94 / 101
In this page, you can enable the log function. You can set
Mode
to
Local
,
Remote
, or
Both
.
Local
indicates to save the log in the local computer.
Remote
indicates to send the log to the remote log server.
Both
indicates to save the log
in the local computer and the remote log server.
To log the events, do as follows:
Step 1
Select
Enable Log
.
Step 2
Select a mode from the drop-down list.
If you select
Remote
or
Both
, enter the IP address and port number of
the server.
Step 3
Click
Apply
to apply the settings.
Step 4
Click
View System Log
to view the detail information of the system
log.
3.4.6
Logout
Choose
Management
>
Logout
. The page as shown in the following figure
appears:
88
Page 95 / 101
Click
Logout
to log out of the configuration page.
3.5
Status
In the
Status
page, you can view the system information and monitor the
performance of the device.
3.5.1
Device Information
Choose
Status
>
Device Info
. The page as shown in the following figure
appears:
89
19216811.live