Page 56 / 234
Scroll up to view Page 51 - 55
USER MANUAL
Peplink Balance Series
-56 / 234 -
Copyright © 2014 Peplink
If Drop-in Mode is going to be configured, the setup wizard will move on to
Drop-in Settings
.
Select the connection type for WAN connection(s) from the following screen:
Depending on the selection of connection type, further configuration may be needed. For example,
PPPoE and Static IP require additional settings for the selected WAN port. Please refer to
Section 12,
Configuring the WAN Interface(s)
for details on setting up DHCP, static IP, and PPPoE.
If
Mobile Internet Connection
is checked, the setup wizard will move on to
Operator Settings
.
If
Custom Mobile Operator Settings
is selected, APN parameters are required to be entered. Some
service providers may charge a fee for connecting to a different APN. Please consult your service
provider for the correct settings.
Page 57 / 234
USER MANUAL
Peplink Balance Series
-57 / 234 -
Copyright © 2014 Peplink
Click on the appropriate check box(es) to select the preferred WAN connection(s). Connection(s) not
selected in this step will be used as backup only. Click
Next>>
to continue.
Choose the time zone of your country/region. Check the box
Show all
to display all time zone options.
Check in the following screen to make sure all settings have been configured correctly, and then click
Save Settings
to confirm.
After finishing the last step in the setup wizard, click
Apply Changes
on the page header to allow the
configuration changes to take effect.
Page 58 / 234
USER MANUAL
Peplink Balance Series
-58 / 234 -
Copyright © 2014 Peplink
8.3
Advanced Setup
Advanced settings can be configured from the
Network
menu.
WAN connections can be configured by entering the corresponding WAN connection information at
Network>Interfaces>WAN
.
Tip
Please refer to
Section 12,Configuring the WAN Interface(s)
, for details on setting up DHCP, static IP, PPPoE,
and mobile Internet connections
.
Page 59 / 234
USER MANUAL
Peplink Balance Series
-59 / 234 -
Copyright © 2014 Peplink
8.4
Cellular WAN
To access cellular WAN settings, click
Network>WAN>Click on Details
.
(
Available on the Peplink 30 LTE only)
Cellular Status
IMSI
This is the International Mobile Subscriber Identity which uniquely identifies the SIM card.
This is applicable to 3G modems only.
MEID
The Balance 30 LTE supports both HSPA and EV-DO.
For Sprint or Verizon Wireless EV-DO users, a unique MEID identifier code (in
hexadecimal format) is used by the carrier to associate the EV-DO device with the user.
This information is presented in hex and decimal format.
ESN
This serves the same purpose as MEID HEX but uses an older format.
IMEI
This is the unique ID for identifying the modem in GSM/HSPA mode.
Page 60 / 234
USER MANUAL
Peplink Balance Series
-60 / 234 -
Copyright © 2014 Peplink
WAN Connection Settings
WAN Connection
Name
This field is for defining a name to represent this WAN connection.
Network Mode
Users have to specify the Network they are on accordingly.
Routing Mode
This option allows you to select the routing method to be used in routing IP frames via the
WAN connection. The mode can be either
NAT
(Network Address Translation) or
IP
Forwarding
. Click the
button to enable IP Forwarding.
Cellular Settings
3G/2G
Band selection to restrict cellular on particular band. Click on the
button to enable the
selection of specific bands.
Data Roaming
This checkbox enables data roaming on this particular SIM card. Please check your
service provider’s data roaming policy before proceeding.
Operator Settings
This setting applies to 3G / EDGE / GPRS modem only. It does not apply to EVDO / EVDO
Rev. A modem.
This allows you to configure the APN settings of your connection. If
Auto
is selected, the
mobile operator should be detected automatically.
The connected device will be
configured and connection will be made automatically afterwards.
If there is any difficulty
in making connection, you may select
Custom
to enter your carrier’s
APN, Login,
Password, and Dial Number
settings manually. The correct values can be obtained from
19216811.live