Netopia 2247-62 Router Manual PDF (Setup & Configuration Guide)
Given below is full router user manual of Netopia 2247-62 router model. You can also download this manual in PDF Format to read later on your computer.
Product user manuals come handy in case you want to know all functionalities of your device, troubleshooting, fist time configuration & setup and in many other situations.
Page 1 / 22
User Manual
The Motorola Netopia
®
2247/57-62
DSL Gateway
4-port Ethernet, 802.11b/g Wi-Fi
Page 2 / 22
2
ENGLISH
IMPORTANT SAFETY INSTRUCTIONS – POWER SUPPLY INSTALLATION.
Connect the power supply cord to
the power jack on the Motorola Gateway. Plug the power supply into an appropriate electrical outlet.
CAUTION:
Depending on the power supply provided with the product, either the direct plug-in power supply blades, power sup-
ply cord plug or the appliance coupler serves as the mains power disconnect. It is important that the direct plug-in power supply,
socket-outlet or appliance coupler be located so it is readily accessible.
(Sweden)
Apparaten skall anslutas till jordat uttag när den ansluts till ett nätverk
(Norway)
Apparatet må kun tilkoples jordet stikkontakt.
TELECOMMUNICATION INSTALLATION.
When using your telephone equipment, basic safety precautions
should always be followed to reduce the risk of fire, electric shock and injury to persons, including the follow-
ing:
•
Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink or laundry tub, in a wet basement or
near a swimming pool.
•
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electrical shock
from lightning.
•
Do not use the telephone to report a gas leak in the vicinity of the leak.
PRODUCT VENTILATION.
The Motorola Gateway is intended for use in a consumer's home. Ambient temperatures around
this product should not exceed 104°F (40°C).
It should not be used in locations exposed to outside heat radiation or trapping of its
own heat. The product should have at least one inch of clearance on all sides except the bottom when properly installed and should
not be placed inside tightly enclosed spaces unless proper ventilation is provided.
All rights reserved. No part of this publication may be reproduced in any form or by any means or used to make any derivative work (such as translation,
transformation or adaptation) without written permission from Motorola, Inc. Motorola reserves the right to revise this publication and to make changes in
content from time to time without obligation on the part of Motorola to provide notification of such revision or change. Motorola provides this guide with-
out warranty of any kind, either implied or expressed, including, but not limited to, the implied warranties of merchantability and fitness for a particular
purpose. Motorola may make improvements or changes in the product(s) described in this manual at any time. MOTOROLA and the Stylized M Logo are
registered in the US Patent & Trademark Office. Microsoft, Windows, Windows Me, and Windows NT are either trademarks or registered trademarks of
Microsoft Corporation in the U.S and/or other countries. Macintosh is a registered trademark of Apple, Inc. Firefox is a registered trademark of the Mozilla
Foundation. All other product or service names are the property of their respective owners.
Safety Information
Page 3 / 22
3
ENGLISH
Thank you for selecting the Motorola Netopia
®
2247- or 2257-62 DSL Gateway. This guide will help
you set up and configure your network.
Check your package contents. It should contain the items shown here:
If you don’t have everything, contact your supplier immediately.
Checklist
1
CD & User Manual
Motorola Gateway
Power Supply
Telephone Cable
Ethernet Cable
Page 4 / 22
4
ENGLISH
1. Decide on a location for the Gateway.
Put the Gateway near a power source, a DSL wall outlet, and in a location where air can circulate
freely around it.
2. Power the Gateway.
Connect the power supply to the power jack on the back panel of the Gateway. Then, plug the
power supply into an electrical outlet. Turn on the Power switch.
The
Power
LED should light solid green.
3. Insert the Motorola Netopia
®
CD into your CDROM drive.
The Motorola Netopia
®
Installation Guide Wizard automates several tasks to get you up and
running easily. These tasks include making the cable connections, adding phones and configuring
the Gateway. Run the Wizard on every Windows-based PC that will connect to your network.
The Installation Guide Wizard will start auto-
matically and the Welcome screen will appear
to step through the process.
Follow the on-screen instructions to make all
of your connections.
Connections
2
Page 5 / 22
5
ENGLISH
When all of your connections are made, your network may look like this:
4. Enable Wireless Protected Setup (WPS) on your Wi-Fi devices.
Adding wireless clients to your network is easier using Wireless Protected Setup (WPS). Older,
non-WPS clients can still be added to the network by configuring them the standard way with
WPA-PSK.
Make sure your wireless clients are running. Press the WPS push-button to begin the exchange,
which may last up to two minutes.
Do not power off your Gateway during the exchange.
The Gateway will display a success message when the exchange has completed.
Note:
Not all client wireless devices support WPS. Refer to their documentation.
19216811.live