19216811.liveUser Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Switching Commands
8-43
202-10088-01, March 2005
Format
speed all {
<100 | 10> <half-duplex | full-duplex>}
Mode
Global Config
Acceptable values are:
100h
100BASE-T half-duplex
100f
100BASE-T full duplex
10h
10BASE-T half duplex
10f
10BASE-T full duplex
storm-control broadcast
This command enables broadcast storm recovery mode. If the mode is enabled, broadcast storm
recovery with high and low thresholds is implemented.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold percentage (as represented in
Table 1
) of the link speed, the switch
discards the broadcasts traffic until the broadcast traffic returns to the low threshold percentage or
less. The full implementation is depicted in the
Table 1
.
Format
storm-control broadcast
Mode
Global Config
no storm-control broadcast
This command disables broadcast storm recovery mode.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold percentage (as represented in
Table 2
) of the link speed, the switch
discards the broadcasts traffic until the broadcast traffic returns to the low threshold percentage or
less. The full implementation is depicted in the
Table 2
.
Table 1.
Broadcast Storm Recovery Thresholds
Link Speed
High
Low
10M
20
10
100M
5
2
1000M
5
2