Page 51 / 56 Scroll up to view Page 46 - 50
www.netcomm.com.au
51
NetComm NB304N – ADSL2+ Wireless N300 Modem
YML304X
Update Software
The router’s software is stored in the FLASH memory and can be upgraded as new software is released.
Click Browse to locate the software file and then click Update Software.
Reboot
This feature allows the router to enable new network configuration to take effect or to clear problems with the modem router’s
network connection.
Page 52 / 56
NETCOMM GATEWAY™ SERIES –
NB304N – ADSL2+ Wireless N300 Modem Router
52
NetComm NB304N – ADSL2+ Wireless N300 Modem
YML304X
www.netcomm.com.au
Technical Data
The following table lists the hardware specifications of the NB304N.
MODEL
NB304N
CPU
BCM63281
DDR SDRAM
64MB DDR2
Serial Flash
4 MB/8 MB/16 MB
Modem Chipset
BCM63281
ADSL Compliance
• G.992.1 (T1.413)
• G.992.2 (G.dmt), G.lite
• G.992.3 (G.bis/ADS L2)
• G.992.5 (ADSL2+)
• Annex L (reach extended ADSL2)
LED Indicators
Power, DSL, Internet, LAN1 – LAN4, WLAN, WPS, USB
Operating Temperature
0 ~ 40 degrees Celsius (operating temperature)
Power input
12VDC – 1.5A
Dimensions & Weight
181 mm (L) x 137 mm (H) x 34 mm (W)
250 grams
Regulatory Compliancy
A-Tick
Electrical Specifications
It is recommended that the NB304N be powered by the supplied 12VDC/1.5A power supply. A replacement power supply is
available from the NetComm Online shop.
Environmental Specifications / Tolerances
The NB304N housing enables it
to operate over a wide variety of temperatures from 0˚C ~
40
˚C.
Page 53 / 56
www.netcomm.com.au
53
NetComm NB304N – ADSL2+ Wireless N300 Modem
YML304X
FAQ
1.
I cannot access the Management Console web page
The default IP address of the unit is 192.168.1.1, so first try to open a web browser to this address. Also check that your
PC/Device is on the same subnet as the router’s Ethernet port.
2.
The router was connected but cannot get back online
Verify your DSL service is active and that the telephone line has been connected securely.
3.
I cannot connect wirelessly
Verify the Wireless network function is enabled and that you are entering the correct Wireless Security key and are able to
see the Wireless network during an SSID scan.
4.
The router has a connection but cannot access the internet
Verify your PC or device is on the same subnet as the Router and that DHCP is enabled.
5.
I cannot access any attached USB Storage
Verify that you have created an appropriate user account and granted the required access permissions for the volume
Page 54 / 56
NETCOMM GATEWAY™ SERIES –
NB304N – ADSL2+ Wireless N300 Modem Router
54
NetComm NB304N – ADSL2+ Wireless N300 Modem
YML304X
www.netcomm.com.au
Legal & Regulatory Information
1.
Intellectual Property Rights
All intellectual property rights (including copyright and trade mark rights) subsisting in, relating to or arising out this Manual are
owned by and vest in NetComm Limited (ACN 002490486) (NetComm) (or its licensors). This Manual does not transfer any right,
title or interest in NetComm’s (or its licensors’) intellectual property rights to you.
You are permitted to use this Manual for the sole purpose of using the NetComm product to which it relates. Otherwise no part of
this Manual may be reproduced, stored in a retrieval system or transmitted in any form, by any means, be it electronic, mechanical,
recording or otherwise, without the prior written permission of NetComm.
NetComm is a trademark of NetComm. All other trademarks are acknowledged to be the property of their respective owners.
2.
Customer Information
The Australian Communications & Media Authority (ACMA) requires you to be aware of the following information and warnings:
1.
This unit may be connected to the Telecommunication Network through a line cord which meets the requirements of the
AS/CA S008-2011 Standard.
2.
This equipment has been tested and found to comply with the Standards for C-Tick and or A-Tick as set by the ACMA.
These standards are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio noise and, if not installed and used in accordance with the instructions
detailed within this manual, may cause interference to radio communications. However, there is no guarantee that
interference will not occur with the installation of this product in your home or office. If this equipment does
cause some
degree of interference
to radio or television reception, which can be determined by turning the equipment off and on, we
encourage the user to try to correct the interference by one or more of the following measures:
Change the direction or relocate the receiving antenna.
Increase the separation between this equipment and the receiver.
Connect the equipment to an alternate power outlet on a different power circuit from that to which the receiver/TV is
connected.
Consult an experienced radio/TV technician for help.
3.
The power supply that is provided with this unit is only intended for use with this product. Do not use this power supply with
any other product or do not use any other power supply that is not approved for use with this product by NetComm. Failure
to do so may cause damage to this product, fire or result in personal injury.
3.
Consumer Protection Laws
Australian and New Zealand consumer law in certain circumstances implies mandatory guarantees, conditions and warranties which
cannot be excluded by NetComm and legislation of another country's Government may have a similar effect (together these are the
Consumer Protection Laws).
Any warranty or representation provided by NetComm is in addition to, and not in replacement of,
your rights under such Consumer Protection Laws.
If you purchased our goods in Australia and you are a consumer, you are entitled to a replacement or refund for a major failure and
for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced
if the goods fail to be of acceptable quality and the failure does not amount to a major failure. If you purchased our goods in New
Zealand and are a consumer you will also be entitled to similar statutory guarantees.
Page 55 / 56
www.netcomm.com.au
55
NetComm NB304N – ADSL2+ Wireless N300 Modem
YML304X
4.
Product Warranty
All NetComm products have a standard one (1) year warranty from date of purchase, however, some products have an extended
warranty option (refer to packaging and the warranty card) (each a Product Warranty). To be eligible for the extended warranty
option you must supply the requested warranty information to NetComm within 30 days of the original purchase by registering
online via the NetComm web site at
www.netcomm.com.au
. For all Product Warranty claims you will require proof of purchase. All
Product Warranties are in addition to your rights and remedies under applicable Consumer Protection Laws which cannot be
excluded (see Section 3 above).
Subject to your rights and remedies under applicable Consumer Protection Laws which cannot be excluded (see Section 3 above),
the Product Warranty is granted on the following conditions:
1.
the Product Warranty extends to the original purchaser (you / the customer) and is not transferable;
2.
the Product Warranty shall not apply to software programs, batteries, power supplies, cables or other accessories supplied
in or with the product;
3.
the customer complies with all of the terms of any relevant agreement with NetComm and any other reasonable
requirements of NetComm including producing such evidence of purchase as NetComm may require;
4.
the cost of transporting product to and from NetComm’s nominated premises is your responsibility;
5.
NetComm does not have any liability or responsibility under the Product Warranty where any cost, loss, injury or damage of
any kind, whether direct, indirect, consequential, incidental or otherwise arises out of events beyond NetComm’s reasonable
control. This includes but is not limited to: acts of God, war, riot, embargoes, acts of civil or military authorities, fire, floods,
electricity outages, lightning, power surges, or shortages of materials or labour; and
6.
the customer is responsible for the security of their computer and network at all times. Security features may be disabled
within the factory default settings. NetComm recommends that you enable these features to enhance your security.
Subject to your rights and remedies under applicable Consumer Protection Laws which cannot be excluded (see Section 3 above),
the Product Warranty is automatically voided if:
1.
you, or someone else, use the product, or attempt to use it, other than as specified by NetComm;
2.
the fault or defect
in your product
is the result of a voltage surge subjected to the product
either by the way of power
supply or communication line, whether caused by thunderstorm activity or any other cause(s);
3.
the fault is the result of accidental damage or damage in transit, including but not limited to liquid spillage;
4.
your product has been used for any purposes other than that for which it is sold, or in any way other than in strict
accordance with the user manual supplied;
5.
your product
has been repaired or modified or attempted to be repaired or modified, other than by a qualified person
at a
service centre
authorised by NetComm;
or
6.
the serial number has been defaced or altered in any way or if the serial number plate has been removed.
5.
Limitation of Liability
This clause does not apply to New Zealand consumers.
Subject to your rights and remedies under applicable Consumer Protection Laws which cannot be excluded (see Section 3 above),
NetComm accepts no liability or responsibility, for consequences arising from the use of this product. NetComm reserves the right
to change the specifications and operating details of this product without notice.
If any law implies a guarantee, condition or warranty in respect of goods or services supplied, and NetComm’s liability for breach of
that condition or warranty may not be excluded but may be limited, then subject to your rights and remedies under any applicable
Consumer Protection Laws which cannot be excluded, NetComm’s liability for any breach of that guarantee, condition or warranty
is limited to: (i) in the case of a supply of goods, NetComm doing any one or more of the following: replacing the goods or supplying
equivalent goods; repairing the goods; paying the cost of replacing the goods or of acquiring equivalent goods; or paying the cost
of having the goods repaired; or (ii) in the case of a supply of services, NetComm doing either or both of the following: supplying the
services again; or paying the cost of having the services supplied again.
To the extent NetComm is unable to limit its liability as set out above, NetComm limits its liability to the extent such liability is lawfully
able to be limited.

Rate

3.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top