User Manual v2.5

Page 51

of 57

Your router should now be updated and will take approx 10 mins to be completed.

Do not take the power off the router or close your browser while the update is being done or

you may lock up your router and will have to send it to us for us to get it back in operational

mode.

If you see the first light start flashing on the router "Boot Status", then the update is done and

wait for it to be solid.

If for some reason you missed this and want to see if update is completed, click on the Status

Tab and wait for it to load. Remember it will take approx 10 mins to be completed.

Once the new firmware is updated, you may need to reapply your previous settings.

Your router is equip with a special function to recover if you take off the power too early or

something goes wrong while doing the update.

Visit mofinetwork.com or www.dummyhelp.com for instructions on how to recover if you

unit does not boot up.

User Manual v2.0

Page 52

of 57

How to Remote Login into the Router:

Remote Login is enabled by default.

However, if you are using a 3G\4G\LTE stick and have not paid or added a public ip option

to your account, you cannot get direct access to the router as the NAT will not let you do this,

If you have a security camera system for example and want to log in directly, you will need

to contact you provider and get a public ip option.

For Rogers and Telus in Canada, you can them for this and they change $5 extra per month.

Telus calls it a VPN options bundle and Rogers calls it a Public IP Access.

We were unable to get this option from Mobilicity or Windmobile.

One you get this option, you will have to put in the VPN apn in the router.

For Rogers customers, this is vpn.com

For Telus customers, then is vpn.telus.com

This can be entered by going in network tab, then usb tab and put it under the APN (Access

Point Name)

User Manual v2.5

Page 53

of 57

How to change the default port 80 for remote access to the router:

By default, the router is set to receive on port 80

If you want to change this, log into the router and go into basic mode

Go to Network Tab then Web Sever

You will be able to change the default settings there.

User Manual v2.0

Page 54

of 57

Regulatory Compliance Notices

FCC Notice

This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to

Part 15, 22 and 24 of the FCC Rules. These limits are

designed to provide reasonable protection against

harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there is

no guarantee that interference will not occur in a

particular installation. If this equipment does cause

harmful interference to radio or television reception,

which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

User Manual v2.5

Page 55

of 57

Increase the separation between the equipment and

receiver.

Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

Consult the dealer or an experienced radio or television

technician for help.

Modifications

The FCC requires the user to be notified that any changes

or modifications made to this device that are not

expressly approved by MoFiNetwork could void the

user’s authority to operate the equipment.

This device complies with Part 15 of the FCC rules.

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two conditions:

This device may not cause harmful interference, and

This device must accept any interference received,

including interference that may cause undesired

operation.