Page 51 / 52 Scroll up to view Page 46 - 50
luxul.com
|
357 South 670 West
|
Suite 160
|
Lindon, UT 84042
|
p: 801-822-5450
|
f: 801-822-5460
User Guide
51
Safety in Hospitals: Wireless devices transmit radio frequency energy and may affect
medical electrical equipment. When installed adjacent to other equipment, it is
advised to verify that the adjacent equipment is not adversely affected.
Power Supply: Use only a Luxul approved power supply output rated at 100-240VDC
and minimum 0.1A. The power supply shall be Listed to UL/CSA 60950-1; and
certified to IEC60950-1 and EN60950-1 with SELV outputs. The device can also be
powered from a compliant POE source. Use of alternative power supply will invali-
date any approval given to this device and may be dangerous.
6.2 FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference in a residential installation.
This equipment uses and can radiate radio frequency energy, and if not installed and
used in accordance with the instructions may cause harmful interference to radio
communications. However; there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
±
Reorient or relocate the receiving antenna.
±
Increase the separation between the equipment and receiver.
±
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
±
Consult the dealer or an experienced radio/TV technician for help.
7: CONTACT LUXUL
For sales questions
please contact our
Sales Department
P: (801) 822-5450
If you experience any
problems, please contact
Technical Support
P: (801) 822-5450
To check for firmware updates or download pre-configured application modules,
visit
luxul.com
.
Page 52 / 52
LUX-UG-XBR-2300
092111058
357 South 670 West
|
Suite 160
| Lindon, UT 84042
p: 801-822-5450
| f: 801-822-5460
Information on this document supersedes all previous versions.
Products and documents subject to change without notice.
Products may be discontinued without notice.
luxul.com
APPENDIX 1: COMMON COMMANDS
Common
Commands
Description
Cmd
Enter the command line mode of a Windows system (applicable to
Windows2000 and higher).
ipconfig
Displays the IP address of the computer. (i.e. ipconfig/all) Must be
run from the command line.
Ping
Used to test for network availability and device/system recognition.
Device sends a packet to the target host and asks for a response.
If the device receives a response from the target host, it can then
see the network response time and connection status between the
local device and target host. Must be run from the command line.
netstat
Displays details of current active network connections including
routing table and network interface information. Can also be used
to count the active network connections. Must be run from the
command line.
Tracert
Displays the path taken by a packet before reaching the target host
and the specific time when it reached each node. Similar to the
Ping command but provides more detailed information. Displays
the entire path and IP address of each node in the path and total
elapsed tim. Must be run from the command line.

Rate

3.5 / 5 based on 2 votes.

Popular Luxul Models

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top