WVC200-210 User Guide

52

WVC200

Compression

G.726

Sampling Rate

8 KHz

Dual Bit Rate

16Kbps

Brightness

Auto/Manual Adjustment

Monitor and

Recording

Software

Included software for multiple camera monitoring and recording to

your hard drive with advanced search by time and date.

WEP/WPA

WEP 64bit/128bit, WPA-TKIP, WPA-PSK

User List

User Rights List to View Video and/or to Camera Control Functions

Username/

Password

Logon authentication 20 characters username and 8 characters

password

NTP

Network Time Protocol Support

SMTP

Simple Mail Transfer Protocol Client allows video clips to be emailed

FTP Client

FTP Client facilitates scheduling transfer of images to an FTP server

DDNS

Dynamic DNS facilitates reaching the camera by a name irrespective of

what the IP address is. FreeDNS, DynDNs, 3322, and TZO is supported.

UPnP

Allows autodiscovery of the camera by other UPnP devices

Dimensions

1.26" x 7.83" x 6.89"

(W x H x D)(32 mm x 199 mm x 175 mm

Unit Weight

1.01 lbs. (0.46 kg)

Power

5VDC, 2.5A Switching Power Supply

Certifications

FCC, CE and UL

Operating Temp

0 ºC to 40 ºC (-32 ºF to 104 ºF)

Storage Temp

-20 ºC to 70 ºC (-4 ºF to 140 ºF)

Operating

Humidity

10% to 80%, Non-Condensing

Storage Humidity

0% to 90%, Non-Condensing

WVC200-210 User Guide

53

WVC210

WVC210

Standards

IEEE802.11g, IEEE802.11b, IEEE802.3, IEEE802.3u, IEEE802.1p (QoS

Priority), IEEE802.1q (VLAN), 802.11e (Wireless QoS)

Ports

Ethernet, Antenna, Microphone in, Speaker Out, Power

Protocols

TCP/IP, HTTP, DHCP, SMTP, FTP, NTP, DNS, UPnP, RTP, RTSP, and DDNS

Button

One Reset Button

Cabling

UTP CAT 5

LEDs

Power, Activity, Ethernet, Wireless

Sensor

1/4" CMOS

Focal Length

500mm~Infinity

Frame Rate

Up to 30 fps

Resolution

640x480, 320x240, 160x120

Illumination

Field of View

60 degrees

Auto Patrol

9 Definable Preset Points by User

Pan

± 67 degrees

Tilt

-34 degrees (down) to +30 degrees (up)

Web UI

Built in Web UI for Easy Browser-Based Configuration (HTTP)

Web Browser

Internet Explorer 5.x or above with ActiveX support for viewing,

recording, playback and setting motion detection; limited support for

Safari and Mozilla Firefox (no motion detection)

Logging

Event Logging (SYSLOG)

Upgrades

Firmware Upgradable Through Web-Browser

Dual Streaming

Codecs

MPEG-4 Simple Profile, MJPEG

Snapshot

JPEG

Image Position

Flip and Mirror

Image Settings

Brightness and Contrast

Motion Detection

4 detection areas with individual sensitivity thresholds; triggers alerts

Compression

G.711 A-law and ì-law

WVC200-210 User Guide

54

WVC210

Sampling Rate

8 KHz

Dual Bit Rate

16Kbps

Image Settings

Brightness and Contrast

Monitor and

Recording

Software

Monitoring and recording for up to 16 cameras

Monitor live video, record, and play back simultaneously

WEP/WPA

WEP 64bit/128bit, WPA-TKIP, WPA-PSK, WPA2-PSK

User List

Three-level user rights list to view video and to control camera

Username/

Password

Logon authentication 20 characters username and 8 characters

password

Physical security

option

Kensington lock

NTP

Network Time Protocol synchronizes camera date and time with your

network

SMTP

Simple Mail Transfer Protocol Client allows video clips to be emailed

FTP Client

FTP Client facilitates scheduling transfer of images to an FTP server

DDNS

Dynamic DNS facilitates accessing the camera by name, irrespective of

the camera IP address

UPnP

Allows auto-discovery of the camera by other UPnP devices

Dimensions

1.26" x 7.83" x 6.89" (32 x 199 x 175 mm)

Unit Weight

1.01 lb. (.46 kg)

Power

5DVC 2.0A Switching Power Supply

Certifications

Wi-Fi, FCC, CE and UL

Operating Temp

-32 to 113°F (0 to 45°C)

Storage Temp

-4 to 140°F (-20 to 70°C)

Operating

Humidity

10 to 80%, Non-condensing

Storage Humidity

0 to 90%, Non-condensing

WVC200-210 User Guide

55

FCC Statement

Regulatory Information

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is

no guarantee that interference will not occur in a particular installation.

If this equipment does

cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

FCC Caution

Any changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate this equipment.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 20cm

between the radiator & your body. To maintain compliance with FCC RF exposure compliance

requirements, please avoid direct contact to the transmitting antenna during transmitting.

This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

We declare that the product is limited in CH1~CH11 by specified firmware controlled in the

USA.

Safety Notices

Do not use this product near water, for example, in a wet basement or near a swimming pool.

Avoid using this product during an electrical storm.

There may be a remote risk of electric

shock from lightning.

WVC200-210 User Guide

56

Safety Notices

Industry Canada (Canada)

Operation is subject to the following two conditions:

1.

This device may not cause interference and

2.

This device must accept any interference, including interference that may cause undesired

operation of the device.

This device has been designed to operate with an antenna having a maximum gain of 3.3 dBi.

Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The

required antenna impedance is 50 ohms.

This device complies with Canadian ICES-003 and RSS210 rules.

Cet appareil est conforme aux normes NMB-003 et RSS210 d'Industry Canada.

User Information for Consumer Products Covered by EU Directive 2002/96/

EC on Waste Electric and Electronic Equipment (WEEE)

This document contains important information for users with regards to the proper disposal

and recycling of Linksys products. Consumers are required to comply with this notice for all

electronic products bearing the following symbol:

WARNING:

Risk of explosion if battery is replaced by an

incorrect type. Dispose of used batteries according to the

instructions.