Page 81 / 90 Scroll up to view Page 76 - 80
75
Appendix F: Regulatory Information
Home Wireless-G Gateway
Appendix F: Regulatory Information
Compliance Information for 2.4-GHz Wireless Products Relevant to the EU and Other Countries Following
the EU Directive 1999/5/EC (R&TTE Directive)
Declaration of Conformity with Regard to the EU Directive 1995/5/EC (R&TTE Directive)
Downloaded from
www.Manualslib.com
manuals search engine
Page 82 / 90
76
Appendix F: Regulatory Information
Home Wireless-G Gateway
The following standards were applied during the assessment of the product against the requirements of the
Directive 1999/5/EC:
Radio: EN 300 328
EMC: EN 301 489-1, EN 301 489-17
Safety: EN 60950
NOTE:
If you need any technical documentation, see the “How to Access Technical
Documents on www.linksys.com/international” section for more information.
Downloaded from
www.Manualslib.com
manuals search engine
Page 83 / 90
77
Appendix F: Regulatory Information
Home Wireless-G Gateway
CE Marking
For the Linksys Wireless-B and Wireless-G products, the following CE mark, notified body number (where applicable), and
class 2 identifier are added to the equipment.
Check the CE label on the product to find out which notified body was involved during the assessment.
National Restrictions
This product may be used in all EU countries (and other countries following the EU directive 1999/5/EC) without any
limitation except for the countries mentioned below:
Ce produit peut être utilisé dans tous les pays de l’UE (et dans tous les pays ayant transposés la directive 1999/5/CE) sans
aucune limitation, excepté pour les pays mentionnés ci-dessous:
Questo prodotto è utilizzabile in tutte i paesi EU (ed in tutti gli altri paesi che seguono le direttive EU 1999/5/EC) senza
nessuna limitazione, eccetto per i paesii menzionati di seguito:
Das Produkt kann in allen EU Staaten ohne Einschränkungen eingesetzt werden (sowie in anderen Staaten die der EU
Direktive 1995/5/CE folgen) mit Außnahme der folgenden aufgeführten Staaten:
Belgium
The Belgian Institute for Postal Services and Telecommunications (BIPT) must be notified of any outdoor wireless link
having a range exceeding 300 meters. Please check http://www.bipt.be for more details.
Draadloze verbindingen voor buitengebruik en met een reikwijdte van meer dan 300 meter dienen aangemeld te worden
bij het Belgisch Instituut voor postdiensten en telecommunicatie (BIPT). Zie http://www.bipt.be voor meer gegevens.
Les liaisons sans fil pour une utilisation en extérieur d’une distance supérieure à 300 mètres doivent être notifiées à
l’Institut Belge des services Postaux et des Télécommunications (IBPT). Visitez
http://www.ibpt.be pour de plus amples détails.
France
In case the product is used outdoors, the output power is restricted in some parts of the band. See Table 1 or check
http://www.art-telecom.fr/ for more details.
or
or
Downloaded from
www.Manualslib.com
manuals search engine
Page 84 / 90
78
Appendix F: Regulatory Information
Home Wireless-G Gateway
Dans la cas d’une utilisation en extérieur, la puissance de sortie est limitée pour certaines parties de la bande. Reportez-
vous à la table 1 ou visitez http://www.art-telecom.fr/ pour de plus amples détails.
Italy
This product meets the National Radio Interface and the requirements specified in the National Frequency Allocation Table
for Italy. Unless operating within the boundaries of the owner’s property, the use of this 2.4 GHz Wireless LAN product
requires a ‘general authorization’. Please check with http://www.comunicazioni.it/it/ for more details.
Questo prodotto è conforme alla specifiche di Interfaccia Radio Nazionali e rispetta il Piano Nazionale di ripartizione delle
frequenze in Italia. Se non viene installato all’interno del proprio fondo, l’utilizzo di prodotti Wireless LAN a 2.4 GHz richiede
una “Autorizzazione Generale”. Consultare http://www.comunicazioni.it/it/ per maggiori dettagli.
Product Usage Restrictions
This product is designed for indoor usage only. Outdoor usage is not recommended.
This product is designed for use with the included integral or external (dedicated) antenna(s). Use of non-dedicated or
third-party antenna(s) is not recommended and is not supported by Linksys.
Power Output of Your Device
To comply with your country’s regulations, you may have to change the power output of your wireless device. Proceed to
the appropriate section for your device.
Table 1: Applicable Power Levels in France
Location
Frequency Range (MHz)
Power (EIRP)
Indoor (No restrictions)
2400-2483.5
100 mW (20 dBm)
Outdoor
2400-2454
2454-2483.5
100 mW (20 dBm)
10 mW (10 dBm)
Note:
The power output setting may not be available on all wireless products.
For more information, refer to the documentation on your product’s CD or at
Downloaded from
www.Manualslib.com
manuals search engine
Page 85 / 90
79
Appendix F: Regulatory Information
Home Wireless-G Gateway
Wireless Adapters
Wireless adapters have the power output set to 100% by default. Maximum power output on each adapter does not exceed
20 dBm (100 mW); it is generally 18 dBm (64 mW) or below. If you need to alter your wireless adapter’s power output,
follow the appropriate instructions for your computer’s Windows operating system:
Windows XP
1.
Double-click the
Wireless
icon in your desktop’s system tray.
2.
Open the
Wireless Network Connection
window.
3.
Click the
Properties
button.
4.
Select the
General
tab, and click the
Configure
button.
5.
In the
Properties
window, click the
Advanced
tab.
6.
Select
Power Output
.
7.
From the pull-down menu on the right, select the wireless adapter’s power output percentage.
Windows 2000
1.
Open the
Control Panel
.
2.
Double-click
Network and Dial-Up Connections
.
3.
Select your current wireless connection, and select
Properties
.
4.
From the
Properties
screen, click the
Configure
button.
5.
Click the
Advanced
tab, and select
Power Output
.
6.
From the pull-down menu on the right, select the wireless adapter’s power setting.
If your computer is running Windows Millennium or 98, then refer to Windows Help for instructions on how to access the
advanced settings of a network adapter.
Wireless Access Points, Routers, or Other Wireless Products
If you have a wireless access point, router or other wireless product, use its Web-based Utility to configure its power
output setting (refer to the product’s documentation for more information).
Downloaded from
www.Manualslib.com
manuals search engine

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top