Page 11 / 86
Scroll up to view Page 6 - 10
3.
Setup WAN connection
Prepare an Ethernet cable for connecting this product to your cable/xDSL modem or Ethernet
backbone.
4.
Power on
Connecting the power cord to power inlet and turning the power switch on, this product will
automatically enter the self-test phase. When it is in the self-test phase, the
Status
indicator will
be lighted ON for about 10 seconds, and then it will be flashed 3 times to indicate that the self-test
operation has finished. Finally, the Status indicator will be continuously flashed once per second
to indicate that this product is in normal operation.
Downloaded from
www.Manualslib.com
manuals search engine
Page 12 / 86
Network Check
1.
Please make sure your PC can get IP address automatically so the WBR-6001 can communicate
with your PC during configuration.
•
Select “Control Panel” > “Network Connections”.
•
Right click the “Local Area Connection” and choose “Properties”.
•
Select the TCP/IP protocol for your network card.
•
Click on the Properties button. You should then see the following screen and make sure you
have selected “Obtain IP address automatically”
2.
Reboot computer to make sure you have received the IP address correctly.
3.
Start your Web browser. In the Address box, enter WBR-6001’s default IP Address:
4.
When prompted, use the following default password to login.
Password:
password
8
Downloaded from
www.Manualslib.com
manuals search engine
Page 13 / 86
Default Settings
IP Address
192.168.0.1
Password
password
Wireless Mode
Enable
SSID
WBR-6001
Security
None
Please enter the default system password in lowercase only.
Downloaded from
www.Manualslib.com
manuals search engine
Page 14 / 86
4. Configuring Wireless Router
LED Indicator for
N_Max
Wireless Router
LED
Function
Color
Statu
s
Description
Status flashed once per second to indicate system
is alive.
Status
System
status
Green
Blinking
WAN
WAN port
activity
Green
On
The WAN port is linked.
Blinking
The WAN port is sending or receiving data.
WLAN
Wireless
activity
Green
Blinking
Sending or receiving data via wireless
An active station is connected to the corresponding
LAN port.
Link.
1~4
Link status
Green
On
The corresponding LAN port is sending or receiving
data.
Blinking
Speed
10/100
Data Rate
Green
On
Data is transmitting in 100Mbps on the
corresponding LAN port.
Reset
To reset system settings to factory defaults
Button
Special
application
10
Downloaded from
www.Manualslib.com
manuals search engine
Page 15 / 86
Login to Configure from Wizard
Activate your browser, and disable the proxy or add the IP address of this product into the exceptions.
Then, type this product’s IP address in the Location (for Netscape) or Address (for IE) field and press
After the connection is established, you will see the web user interface of this product. There are two
appearances of web user interface: for general users and for system administrator.
To log in as an administrator, enter the system password (the default password is ”password”) in the
System Password field and click on the Log in button. If the password is correct, the web appearance
will be changed into administrator configure mode. As listed in its main menu, there are several
options for system administration.
The user can setup step by step to finish the connection with Wizard.
7
Downloaded from
www.Manualslib.com
manuals search engine
19216811.live