Page 11 / 68
                                                    Scroll up to view Page 6 - 10
                                                
                    
2 Hardware Installation 
HG232f 300Mbps Wireless Router 
User Guide 
2-4 
Figure 2-3
Shows the cable connections of a CATV broadband network after the router 
is installed on the network 
1. Power adapter of the router 
2. Router 
3. Desktop computer 
4. Cable modem 
5. Power adapter of the cable modem 
6. CATV network interface on the wall 
 
                 
                                
                    
                        Page 12 / 68
                                            
                    
HG232f 300Mbps Wireless Router 
User Guide 
2 Hardware Installation 
2-5 
2.4 Powering On the Router 
Press the 
On/Off
button on the side panel to power the router on. When the 
Power
indicator light remains lit, you can consider that the router to be working properly. 
To power the router off, press the 
On/Off
button again, and then unplug the power adapter. 
 
                 
                                
                    
                        Page 14 / 68
                                            
                    
HG232f 300Mbps Wireless Router 
User Guide 
3 Configuration of Internet Access Parameters 
3-1 
3 
Configuration of Internet Access Parameters 
3.1 Logging In to the Web-based Configuration Utility 
Most of the router parameters are pre-set before delivery to meet common home 
application scenarios. To check the router's working status or configure certain advanced 
network functions, use the web-based configuration utility. 
To log in to the web-based configuration utility: 
Step 1
Set the network connection of your computer to obtain an IP address automatically. 
By default, the Dynamic Host Configuration Protocol (DHCP) function is enabled. The 
router then assigns an IP address to your computer automatically. 
The configuration procedure on the computer running the Windows 7 operating 
system is as follows: 
1.
Choose 
start
> 
Control Panel
> 
Network and Internet
> 
Network and Sharing 
Center
> 
Change adapter settings
. 
2.
Right-click 
Local Area Connection
and choose 
Properties
. 
3.
Double-click 
Internet Protocol Version 4 (TCP/IPv4)
. 
 
                 
                                
                    
                        Page 15 / 68
                                            
                    
3 Configuration of Internet Access Parameters 
HG232f 300Mbps Wireless Router 
User Guide 
3-2 
4.
Select 
Obtain an IP address automatically
and 
Obtain DNS server address 
automatically
, and click
OK
. 
5.
Go back to the former page, and click 
OK
.