Page 156 / 172 Scroll up to view Page 151 - 155
FRITZ!Box 6490 Cable
156
Uninstalling Supplementary Software
2.
Click the “Programs and Features” entry.
The “Uninstall or change a program” list shows all of the
programs installed on your computer.
3.
Mark the AVM program you want to remove in the list.
4.
Click the “Uninstall” button.
The program will be removed.
Uninstalling Programs in Windows 7
1.
Open “Start / Control Panel / Programs”.
2.
Under “Programs and Features”, click “Uninstall a pro-
gram”.
3.
Mark the AVM program you want to remove in the list.
4.
Click the “Uninstall/Change” button.
The program will be removed.
Uninstalling Programs in Windows Vista
1.
Open “Start / Settings / Control Panel / Programs and
Functions”.
2.
Mark the AVM program you want to remove in the list.
3.
Click the “Uninstall/Change” button and confirm with
“Continue”.
The program will be removed.
Page 157 / 172
Technical Specifications
FRITZ!Box 6490 Cable
157
26
Technical Specifications
Facts worth knowing: Here you will find comprehensive technical data
on your FRITZ!Box 6490 Cable.
26.1
Network Access Interface
The FRITZ!Box 6490 Cable fulfills the interface specification
for public network in accordance with the following standards
and directives:
ETSI TS 102 639 (DOCSIS or EuroDOCSIS 3.0 cable
broadband access for Internet and telephony)
IETF RFC 3261 (Session Initiation Protocol for Voice over IP)
Broadband Forum TR-069 (CPE WAN Management Protocol)
26.2
Ports and Interfaces
Cable port
cable modem compliant with DOCSIS 3.0 or
EuroDOCSIS 3.0, downward compatible with
EuroDOCSIS 1.0, 1.1 and 2.0 supports up to 24 chan-
nels in the receive direction and up to 8 channels in the
send direction
Two a/b ports with RJ11 and TAE sockets for connecting
two analog terminal devices
One ISDN S
0
NT port
S
0
bus with support for ISDN terminal devices; the CIP
services voice, telephony, audio 3.1 and fax G2/G3 are
supported
DECT Base Station
Four LAN ports via RJ45 sockets (standard Ethernet,
10/100/1000 Base-T)
Two USB host controllers (USB version 2.0)
Page 158 / 172
FRITZ!Box 6490 Cable
158
Router Functions
Wireless access point with support for wireless LAN ra-
dio networks
IEEE 802.11a – 54 Mbit/s
IEEE 802.11b – 11 Mbit/s
IEEE 802.11g – 54 Mbit/s
IEEE 802.11n – 450 Mbit/s
IEEE 802.11ac – 1300 Mbit/s
26.3
Router Functions
Router
DHCP server
Firewall with IP masquerading/NAT
IPv4 and IPv6
Parental controls and filter lists
Port Forwarding
Dynamic DNS
VPN
26.4
User Interface and Display
Configuration and status messages via a web browser on
a connected computer
Five LEDs indicate the condition of the device
26.5
Tones
Busy signal: 500 ms tone, 500 ms pause, +/– 20 ms
Ring tone: 1 s tone, 4 s pause +/– 100 ms
Page 159 / 172
Device Properties
FRITZ!Box 6490 Cable
159
26.6
Device Properties
Dimensions (W x D x H): circa 245 x 55 x 175 mm
FRITZ!OS can be updated (installed by your cable net-
work provider)
Conforms to CE standards
Ambient conditions
operating temperature: 0 °C – +40 °C
storage temperature: -20 °C – +70 °C
relative humidity (operation): 10% – 90%
relative humidity (idle): 5% – 95%
Supply voltage: 230 V / 50 Hz
Maximum power consumption: 25 W
Average power consumption: 11 W
The average power consumption was determined at
room temperature (23 °C to 27 °C) with the following
load:
wireless LAN on; no devices registered via wireless LAN
DECT on; one telephone registered via DECT; no
active calls
one network device connected to a LAN port; no data
transfer; other LAN ports not in use
Page 160 / 172
FRITZ!Box 6490 Cable
160
Cable
26.7
Cable
Network Cable (yellow)
Use
The network cable is used to connect computers and network devic-
es to the FRITZ!Box 6490 Cable.
AVM recommends using a network cable no more than
100 meters long.
Additional network cable is required if you would like to use all
of the FRITZ!Box 6490 Cable network ports.
Extension
You can extend one or both ends of the network cable. You will need
the following components to extend the cable:
Standard CAT-5 network cable
When components of a category smaller than Cat 5 are
used, reduced transmission rates may result.
You can use both straight cables and crosslink cables.
1 standard RJ45 CAT-5 double coupling with a 1:1 pinout
All components are available from specialized vendors.
Replacement
The network cable is a standard cable.
As a replacement, use a standard Cat-5 network cable.
Replacement cable is available from specialized vendors.

Rate

4.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top