Page 16 / 120
Scroll up to view Page 11 - 15
15
7.
Hardware Installation
AP Router Mode:
One type of Internet connection is required. Please either connect the network cable from your DSL/Cable modem to the RJ45 port
on the TRAVEL ROUTER or connect a 3G adapter to the USB port.
Note:
When 3G USB adapter is connected, RJ45 automatically is set to LAN mode.
Page 17 / 120
16
AP Mode:
Connect the network cable to the RJ45 port.
Power On :
Use the AC Power cord to connect TRAVEL ROUTER and outlet or any other power supplies to provide the electricity to the device.
Wired Network
Page 18 / 120
17
8.
Configuring Travel Router
This section will show you how to configure the device using the web-based configuration interface.
Please use your wireless network adapter to connect the TRAVEL ROUTER.
Default Settings
IP Address
192.168.0.1
Username / Password
admin / admin
Wireless Mode
Enable
Wireless SSID
EnGenius
xxxxxx
Wireless Security
None
Note:
xxxxxx
mentioned in the wireless SSID above is the last 6 characters of your device MAC Address. This can be found on the device body label and is
unique for each device.
Page 19 / 120
18
8.1
Setup Wizard
1.
Open a web browser (Internet Explorer/Firefox/Safari) and enter the IP Address
Note:
If you have changed the default IP Address assigned to the TRAVEL ROUTER, ensure you enter the correct IP Address
.
2.
The default username and password is
admin
. Once you have entered the correct username and password, click the
OK
button to open the web-base configuration page.
Page 20 / 120
19
3.
You will see the following screen if the log on process is successful.
4.
Click
Wizard
to enter the Setup Wizard.
Then click
Next
to begin the wizard.
19216811.live