Page 16 / 94
Scroll up to view Page 11 - 15
16
ESR-9753
should be setup as depicted above.
Make sure your
DSL/CABLE modem
is setup and working. Else take the help
of your internet service provider.
Click
<Next>
to proceed.
Check the MODEM and ESR-9753 connection. It should be as shown below.
Downloaded from
www.Manualslib.com
manuals search engine
Page 17 / 94
17
Check power connection for modem as well as ESR-9753.
Make sure the antenna is connected to rear panel of ESR-9753.
Click
<Next>
to proceed.
Notice the LED will light up at this stage. If not, check your procedures again.
Click
<Next>
to configure WAN & Wireless settings.
Downloaded from
www.Manualslib.com
manuals search engine
Page 18 / 94
18
User name and password are
admin/admin.
Click
<OK>
. Your default
browser will connect to ESR-9753 Web Server
.
Downloaded from
www.Manualslib.com
manuals search engine
Page 19 / 94
19
Click
<Next>
to enter mode selection.
Select the mode that ESR-9753 is going to be and set its configurations.
AP
Repeater mode
does not enable WAN interface, Setup Wizard will skip WAN
Configuration.
Click
<Next>
to automatically detect your
Internet
Network
settings.
Downloaded from
www.Manualslib.com
manuals search engine
Page 20 / 94
20
You could choose your service type or select Others to setup WAN
configurations manually.
Smart Wizard has detected DHCP client. Configure the host name and MAC
address of ESR-9753. Click Next to proceed.
Smart Wizard has finished setting up
WAN Configuration
. Click
<Next>
to
proceed.
Downloaded from
www.Manualslib.com
manuals search engine
19216811.live