Page 26 / 139
Scroll up to view Page 21 - 25
22
II
‐
4.
WPS Setup
If your wireless device supports WPS (Wi
‐
Fi Protected Setup) then you can use this
method to connect to the BR
‐
6228nS V2/nC V2’s Wi
‐
Fi network.
1.
Press the
WPS button
on the BR
‐
6228nS V2/nC V2
for 2 – 5 seconds to activate WPS. The WLAN LED
will flash to indicate that WPS is active.
2.
Within two minutes
, press the WPS button on the
wireless device/client
to activate its WPS.
3.
The devices will establish a connection. Repeat for additional wireless devices.
Please check the instructions for your wireless device for how long
you need to hold down its WPS button to activate WPS.
II
‐
5.
Reset to Factory Default Settings
If you experience problems with your BR
‐
6228nS V2/nC V2, you can reset the
device back to its factory settings. This resets
all
settings back to default.
1.
Press and hold the WPS/Reset button found on the back panel for at least
10 seconds, until the power LED begins to flash.
2.
Release the button when the power LED is
flashing.
3.
Wait for the BR
‐
6228nS V2/nC V2 to restart. The BR
‐
6228nS V2/nC V2 is
ready for setup when the power LED displays
on.
Page 27 / 139
23
III.
Browser Based Configuration Interface
After you have setup the BR
‐
6228nS V2/nC V2 as detailed in
II. Installation
or
the included
Quick Installation Guide
, you can use the browser based
configuration interface to configure advanced settings.
Please ensure that your computer is set to use a dynamic IP
address. Refer to
IV
‐
1. Configuring your IP address
for more
information.
III
‐
1.
Login
1.
To access the browser based configuration interface enter
http://edimax.setup
into the URL bar of a browser on a network device
connected to the same Wi
‐
Fi network as the BR
‐
6228nS V2/nC V2.
If you can not access
http://edimax.setup
, connect the device to a
computer using an Ethernet cable and try again.
2.
You will be prompted for a username and password. The default
username is “admin” and the default password is “1234”.
Page 28 / 139
24
3.
You will arrive at the “Status” screen. Use the menu down the left side to
navigate.
Page 29 / 139
25
III
‐
2.
Save Settings
1.
After you configure any settings, click the “Save Settings” button at the
bottom of the screen to save your changes.
The device needs to restart in order to bring any changes into
effect.
2.
Then, click “Click here to restart” in order to restart the device and bring
the changes into effect.
3.
To make several changes at once, use the “Save Settings” button after
each change and then click “click here to restart” after your final change.
Only one restart is necessary as long as each change is saved with the “Save
Settings” button.
After you click “click here to restart”, all saved changes will come
into effect.
Page 30 / 139
26
III
‐
3.
Main Menu
The main menu displays different options depending on your device’s
operating mode.
Wi
‐
Fi Router
Access Point
Range Extender
19216811.live