Page 26 / 298
Scroll up to view Page 21 - 25
Vigor2930 Series User’s Guide
18
In the
Quick Start Wizard
, you can configure the router to access the Internet with different
protocol/modes such as
PPPoE
,
PPTP
,
L2TP
,
Static
IP
or
DHCP
. The router supports the
DSL WAN interface for Internet access.
2.2.1 PPPoE
PPPoE stands for
Point-to-Point Protocol over Ethernet
. It relies on two widely accepted
standards: PPP and Ethernet. It connects users through an Ethernet to the Internet with a
common broadband medium, such as a single DSL line, wireless device or cable modem. All
the users over the Ethernet can share a common connection.
PPPoE is used for most of DSL modem users. All local users can share one PPPoE
connection for accessing the Internet. Your service provider will provide you information
about user name, password, and authentication mode.
If your ISP provides you the
PPPoE
connection, please select
PPPoE
for this router. The
following page will be shown:
User Name
Assign a specific valid user name provided by the ISP.
Password
Assign a valid password provided by the ISP.
Confirm Password
Retype the password.
Page 27 / 298
igor2930 Series User’s Guide
19
Click
Next
for viewing summary of such connection.
Click
Finish.
A page of
Quick Start Wizard Setup OK!!!
will appear.
Then, the system
status of this protocol will be shown.
Page 28 / 298
Vigor2930 Series User’s Guide
20
2.2.2 PPTP/L2TP
Click
PPTP
as the protocol. Type in all the information that your ISP provides for this
protocol.
Click
Next
for viewing summary of such connection.
Click
Finish.
A page of
Quick Start Wizard Setup OK!!!
will appear.
Then, the system
status of this protocol will be shown.
Page 29 / 298
igor2930 Series User’s Guide
21
2.2.3 Static IP
Click
Static IP
as the protocol. Type in all the information that your ISP provides for this
protocol.
After finishing the settings in this page, click
Next
to see the following page.
Click
Finish.
A page of
Quick Start Wizard Setup OK!!!
will appear.
Then, the system
status of this protocol will be shown.
Page 30 / 298
Vigor2930 Series User’s Guide
22
2.2.4 DHCP
Click
DHCP
as the protocol. Type in all the information that your ISP provides for this
protocol.
After finishing the settings in this page, click
Next
to see the following page.
Click
Finish.
A page of
Quick Start Wizard Setup OK!!!
will appear.
Then, the system
status of this protocol will be shown.
19216811.live