Page 146 / 173
Scroll up to view Page 141 - 145
Vigor2900 Series User’s Guide
140
8.
Set
Dial-In settings
as shown below to allow Router B dial-in to build VPN connection.
If an
IPSec-based
service is selected, you may further specify the remote peer IP
Address, IKE Authentication Method and IPSec Security Method for this Dial-In
connection. Otherwise, it will apply the settings defined in
IPSec General Setup
above.
If a
PPP-based service
is selected, you should further specify the remote peer IP Address,
Username, Password, and VJ Compression for this Dial-In connection.
9.
At last, set the remote network IP/subnet in
TCP/IP Network Settings
so that Router A
can direct the packets destined to the remote network to Router B via the VPN
connection.
Page 147 / 173
Vigor2900 Series User’s Guide
141
Settings in Router B in the remote office:
1.
Choose
VPN and Remote Access Setup
on the
Advanced Setup
group
.
2.
Select
Remote Access Control
Setup
. The following page will appear. Enable the
necessary VPN service and click
OK
.
3.
Then, return to
VPN and Remote Access Setup
page and choose
PPP General Setup
.
4.
For using
PPP based
services, such as PPTP, L2TP, you have to set general settings in
PPP General Setup
.
For using
IPSec-based
service, such as IPSec or L2TP with IPSec Policy, you have to
set general settings in
IPSec General Setup
, such as the pre-shared key that both parties
have known.
Page 148 / 173
Vigor2900 Series User’s Guide
142
5.
Return to
VPN and Remote Access Setup
page and choose
LAN-to-LAN
Profile
Setup.
Click on one index number to edit a profile.
6.
Set
Common Settings
as shown below. You should enable both of VPN connections
because any one of the parties may start the VPN connection.
7.
Set
Dial-Out Settings
as shown below to dial to connect to Router B aggressively with
the selected Dial-Out method.
If an
IPSec-based
service is selected, you should further specify the remote peer IP
Address, IKE Authentication Method and IPSec Security Method for this Dial-Out
connection.
Page 149 / 173
Vigor2900 Series User’s Guide
143
If a
PPP-based
service is selected, you should further specify the remote peer IP Address,
Username, Password, PPP Authentication and VJ Compression for this Dial-Out
connection.
8.
Set
Dial-In settings
as shown below to allow Router A dial-in to build VPN connection.
If an
IPSec-based
service is selected, you may further specify the remote peer IP
Address, IKE Authentication Method and IPSec Security Method for this Dial-In
connection. Otherwise, it will apply the settings defined in
IPSec General Setup
above.
Page 150 / 173
Vigor2900 Series User’s Guide
144
If a
PPP-based
service is selected, you should further specify the remote peer IP Address,
Username, Password, and VJ Compression for this Dial-In connection.
9.
At last, set the remote network IP/subnet in
TCP/IP Network Settings
so that Router B
can direct the packets destined to the remote network to Router A via the VPN
connection.
19216811.live