Page 16 / 241 Scroll up to view Page 11 - 15
Vigor2130 Series User’s Guide
8
1.3 Hardware Installation
Before starting to configure the router, you have to connect your devices correctly.
1.
Connect Line port to land line jack with a RJ-11 cable (Vn model).
2.
Connect this device to a modem with an Ethernet cable.
3.
Connect one port of 4-port switch to your computer with a RJ-45 cable. This device
allows you to connect 4 PCs directly.
4.
Connect Phone port to a conventional analog telephone.
5.
Connect detachable antennas to the router for Vigor2130 series (n model).
6.
Connect one end of the power cord to the power port of this device. Connect the other
end to the wall outlet of electricity.
7.
Power on the router.
8.
Check the
ACT
and
WAN
,
LAN
LEDs to assure network connections.
(For the detailed information of LED status, please refer to section 1.1.)
Caution
:
1. Each of the Phone ports can be connected to an analog phone only. Do not connect the
phone ports to the land line jack. Such connection might damage your router.
2. When the power is shutdown, VoIP phone will be disconnected. However, a phone set
connected to Phone 2 port can be used as the traditional telephone for the line will be
guided to land line jack via the router (loop through).
Page 17 / 241
Vigor2130 Series User’s Guide
9
Stand Installation
The Vigor2130 must be placed erectly. Therefore you have to install a stand onto the router to
make it standing firmly. Please follow the figures listed below to finish the installation.
c
d
e
f
Page 18 / 241
Vigor2130 Series User’s Guide
10
1.4 Printer Installation
You can install a printer onto the router for sharing printing. All the PCs connected this router
can print documents via the router. The example provided here is made based on Windows
XP/2000. For Windows 98/SE/Vista, please visit
www.draytek.com
.
Before using it, please follow the steps below to configure settings for connected computers
(or wireless clients).
1.
Connect the printer with the router through USB/parallel port.
2.
Open
Start->Settings-> Printer and Faxes
.
3.
Open
File->Add a New Computer
. A welcome dialog will appear. Please click
Next
.
Page 19 / 241
Vigor2130 Series User’s Guide
11
4.
Click Local printer attached to this computer and click Next.
5.
In this dialog, choose
Create a new port Type of port
and use the drop down list to
select
Standard TCP/IP Port
. Click
Next
.
Page 20 / 241
Vigor2130 Series User’s Guide
12
6.
In the following dialog, type
192.168.1.1
(router’s LAN IP) in the field of
Printer Name
or IP Address
and type
IP_192.168.1.1
as the port name. Then, click
Next
.
7.
Click Standard and choose Generic Network Card.
8.
Then, in the following dialog, click
Finish
.

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top