12

D-Link GO-RT-N150 User Manual

Section 3 - Configuration

Easy Setup Wizard

Once logged into the web interface of the router, the Easy Setup Wizard will appear and perform WAN auto detection to obtain

the type of Internet connection you are using.

13

D-Link GO-RT-N150 User Manual

Section 3 - Configuration

According to the detection result, the wizard will

indicate the type of Internet connection that you are

currently using.

To configure your wireless network, click

Configure

in

Wireless Settings. Select the type of Wireless security

you use (Disable Wireless Security or AUTO-WPA/WPA2)

and enter the network name (SSID, Service Set Identifier)

and security password. The network name (SSID) is the

name of your wireless network. Create a name using up

to 32 characters.

If the type is Dynamic IP (DHCP), click

Save

to continue.

If the type is PPPoE, enter your PPPoE username

and password. Click

Next

to continue.

If the type is Static IP, please enter the IP

address, subnet mask, gateway, and DNS server

addresses that your ISP assigned to you. Click

Connect

to continue.

Note: Make sure you remove any PPPoE software

from your computer. The software is no longer

needed and will not work through a router.

14

D-Link GO-RT-N150 User Manual

Section 3 - Configuration

In the final stage of the Easy setup wizard, the summary

will show your current configuration. Click

Save

to

complete the setup.

When the internet connectivity is established, the

webpage will be redirected to the D-Link Website.

15

D-Link GO-RT-N150 User Manual

Section 3 - Configuration

If you opt to set up your Internet connection manually, you will be redirected to a WAN page that allows you to select the type

of your Internet connection and enter the correct configuration parameters.

Select your Internet connection type using the “

My

Internet Connection is”

drop-down menu.

Click

Save Settings

when you have configured the

connection.

Internet Configuration

Dynamic (Cable)

Use this mode to disable NAT on the router and

turn it into an Access Point

Select your Internet connection type using the

“Internet connection type” drop-down menu.

Access Point

Mode:

Internet

Connection

Type:

16

D-Link GO-RT-N150 User Manual

Section 3 - Configuration

Dynamic IP Address (DHCP)

Select

Dynamic IP (DHCP)

to obtain IP Address

information automatically from your ISP. Select this

option if your ISP did not provide you with any IP

numbers to use. This option is commonly used for

cable modem services.

The Host Name is optional but may be required

by some ISPs.

Enter the Primary DNS server IP address assigned

by your ISP.

Maximum Transmission Unit - you may need to

change the MTU for optimal performance with

your specific ISP. 1500 is the default MTU.

The default MAC Address is set to the Internet

port’s physical interface MAC address on the

router. It is not recommended that you change the

default MAC address unless required by your ISP.

You can use the

Clone Your PC’s MAC Address

button to replace the Internet port’s MAC address

with the MAC address of your Ethernet card.

My Internet

Connection:

Host Name:

DNS

Addresses:

MTU:

MAC

Address: