Page 31 / 66
Scroll up to view Page 26 - 30
31
D-Link EBR-2310 User Manual
Section 3 - Configuration
System Settings
Use this option to save the current router
configuration settings to a file on the hard disk
of the computer you are using. First, click the
Save button. You will then see a file dialog,
where you can select a location and file name
for the settings.
Use this option to load previously saved
router configuration settings. First, use the
Browse control to find a previously save file
of configuration settings. Then, click the Load
button to transfer those settings to the router.
This option will restore all configuration settings
back to the settings that were in effect at the
time the router was shipped from the factory.
Any settings that have not been saved will be
lost, including any rules that you have created. If
you want to save the current router configuration
settings, use the Save button above.
Save Settings to
Local Hard Drive:
Load Settings
from Local Hard
Drive:
Restore to Factory
Default Settings:
Page 32 / 66
32
D-Link EBR-2310 User Manual
Section 3 - Configuration
Firmware Upgrade
Click on the link in this screen to find out if there
is an updated firmware; if so, download the new
firmware to your hard drive.
After you have downloaded the new firmware,
click Browse in this window to locate the
firmware update on your hard drive.
Click
Save
Settings
to complete the firmware upgrade.
Firmware
Upgrade:
Browse:
You can upgrade the firmware of the Router here. Make sure the firmware you want to use is on the local hard drive of
the computer. Click on
Browse
to locate the firmware file to be used for the update. Please check the D-Link support
D-Link support site.
Page 33 / 66
33
D-Link EBR-2310 User Manual
Section 3 - Configuration
System Check
VCT is an advanced feature that integrates a
LAN cable tester on every Ethernet port on the
router. Through the graphical user interface
(GUI), VCT can be used to remotely diagnose
and report cable faults such as opens, shorts,
swaps, and impedance mismatch. This feature
significantly reduces service calls and returns
by allowing users to easily troubleshoot their
cable connections.
The Ping Test is used to send Ping packets to
test if a computer is on the Internet. Enter the
IP Address that you wish to Ping, and click
Ping
.
Virtual Cable
Tester (VCT) Info:
Ping Test:
Page 34 / 66
34
D-Link EBR-2310 User Manual
Section 3 - Configuration
Device Information
This page displays the current information for the WBR-2310. It will display the LAN, WAN, and Wireless information.
If your WAN connection is set up for a Dynamic IP address then a
Release
button and a
Renew
button will be displayed.
Use
Release
to disconnect from your ISP and use
Renew
to connect to your ISP.
If your WAN connection is set up for PPPoE, a
Connect
button and a
Disconnect
button will be displayed. Use
Disconnect
to drop the PPPoE connection and use
Connect
to establish the PPPoE connection.
Displays the MAC address and the private
(local) IP settings for the router.
Displays the MAC address and the public IP
settings for the router.
LAN:
WAN:
Page 35 / 66
35
D-Link EBR-2310 User Manual
Section 3 - Configuration
Log
First Page:
Last Page:
Previous:
Next:
Clear:
View the first page of the log.
View the last page of the log.
View the previous page.
View the next page.
Clear the log.
19216811.live