19216811.live69
[Tone1ON][Tone1OFF][Tone2ON
][Tone2OFF ]]
tone
-print
Display tone configuration.
[num]
Tone index(1~4:Disconnect tone / 5~8:Remote ring back tone).
Example:
tone -print
tone 1 480 620 8 8 50 50 1023 1023
usr/config$
Parameter Usages:
-print
show all tone configuration
[num]
tone index. 1~4 is disconnect tone, 5~8 is remote ring back tone.
For FXO ports Gateway must detect disconnect tone to determine
when to disconnect the call, so user must set disconnect tone of
PBX or PSTN network connected to FXO ports.
When making a call from FXO ports, there are 2 ways to detect cal
lee has already picked up the call, one is to detect reverse signal,
the other is to detect the termination of ring back tone, so user
must set ring back tone of PBX or PSTN network.
(If user doesn’t know about the frequency of disconnect tone or
ring back tone, please refer to
[record]
command to detect
frequency.)
For each tone may has 1 set or 2 sets (high and low) of frequencies.
If user wants to set 0 in on/off time, please set “1023” represent “0”.
(ex.
tone 1 620 480 8 8 50 50 1023 1023
)
(
tone “index of tone” “frequency of high” “frequency of low”
“level of high” “level of low” “on time of high” “off time of high”
“on time of low” “off time of low”
)
4.2.19 [fxopwd]
This command is for FXO ports.
-------------------------------------------------------------------------------------------------
usr/config$ fxopwd
FXO password information and configuration
Usage:
fxopwd -add [passwd number]