Page 46 / 83
Scroll up to view Page 41 - 45
44
Figure 3.20: TFTP information
4
Press the OK button to start the upgrade procedure.
5
Please press the “Flash Clean” button when the procedure is finished.
6
After pressing the “Flash Clean” button, please press the “Reboot System”
button to make it reboot.
Please pay more attentions on the file name you used. The file name
with the prefix “2m” is the complete firmware, it will take more times for
the downloading and upgrading. About the file name without the prefix
“2m”, it’s only for the application layer firmware. In fact, the latest version
firmware is only changed in the application layer.
Please use the flash clean web to make all the configuration back to the
default setting if the upgrade procedure was finished.
Page 47 / 83
45
3.15 Flash Clean
Users could make all the configurations back to the default setting by this button.
The password of the account and the networking configuration couldn’t be back to
the default setting by this command. (see figure 3.21)
Figure 3.21: Flash Command
Page 48 / 83
46
3.16 Commit
This web page could save the configurations if users change some configurations.
This is necessary for users change the configurations. (see figure 3.22)
Figure 3.22: Commit the data
Page 49 / 83
47
3.17 Reboot System
This web page will restart the whole system. This is the necessary step for the
changing the configurations and makes it executed. (see figure 3.23)
Figure 3.23: Reboot System
Page 50 / 83
48
4. Command List
4.1 Hyper Terminal Setting
A terminal emulator is needed when using RS-232 port to configure Gateway. There
are kinds of terminal emulator software. Here, we use Microsoft HyperTerminal to
depict how to set up terminal emulator:
1.
Execute the
Hyper Terminal
program, and then the following windows will
pop-up on
the
screen.
(START
–
Program files
– Accessories –
Communication – Hyper Terminal)
Figure 4.1: Hyper Terminal
19216811.live