Page 71 / 88
Scroll up to view Page 66 - 70
DSL-2730B User Manual
Click
Add
to add a static route. The page shown in the following figure appears.
Destination Network Address
: The destination IP address of the router.
Subnet Mask
: The subnet mask of the destination IP address.
Use Gateway IP Address
: The gateway IP address of the router.
Use Interface
: The interface name of the router output port.
You can click
Use Gateway IP Address
or
Use Interface
.
Click
Apply
to save the settings.
4.4.11.2 Default Gateway
Choose
ADVANCED
>
Routing
and click
Default Gateway
. The page shown
in the following figure appears.
Select the WAN interface as your default gateway. Click
Apply
to save the
settings.
68
Page 72 / 88
DSL-2730B User Manual
4.4.11.3 Policy Routing
Choose
ADVANCED
>
Routing
and click
policy
Routing
. The page shown in
the following figure appears.
The policy route binds one WAN connection and one LAN interface.
Click
Add
, the page shown in the following figure appears.
69
Page 73 / 88
DSL-2730B User Manual
4.4.12
RIP
Choose
ADVANCED
>
Routing
and click
RIP
. The page shown in the following
figure appears. This page is used to select the interfaces on your device that
use RIP and the version of the protocol used.
If you are using this device as a RIP-enabled device to communicate with others
using the routing information protocol, enable RIP and click
Apply
to save the
settings.
4.4.13
MultiNat
Network address translation (NAT) is the process of modifying network address
information in IP packet headers while in transit across a traffic routing device
for the purpose of remapping a given address space into another. The packets
which source IP address match between “internalStart” and “internalEnd” in the
NAT table come to the router, the router changes source IP of this packet by the
IP address that set between “externalStart” and “externalEnd”, then transmit the
packet into Internet.
Choose
ADVANCED
>
MultiNat
. The page shown in the following figure
appears.
70
Page 74 / 88
DSL-2730B User Manual
Click
Add
, the page shown in the following figure appears.
In this page, please select the proper type; select the proper
Use interface
, and
configure the other parameters in this page.
After finishing setting, click
Apply
to save the settings.
4.4.14
Schedules
Choose
ADVANCED
>
Schedules
. The page shown in the following figure
appears.
71
Page 75 / 88
DSL-2730B User Manual
Click
Add
to add schedule rule. The page shown in the following figure appears.
Click
Apply
to save the settings.
4.4.15
Logout
Choose
ADVANCED
>
Logout
. The page shown in the following figure
appears. In this page, you can log out of the configuration page.
72
19216811.live