Page 101 / 120
Scroll up to view Page 96 - 100
97
D-Link DIR-608 User Manual
Section 4 - Connecting to a Wireless Network
5. Type a name to identify the network.
6. To configure advanced settings, click the
icon.
Click
Next
to continue.
Page 102 / 120
98
D-Link DIR-608 User Manual
Section 4 - Connecting to a Wireless Network
7. The following window appears while the DIR-608 is being configured.
Wait for the configuration to complete.
8. The following window informs you that WPS on the DIR-608 has been set
up successfully.
Make a note of the security key as you may need to provide this security key
if adding an older wireless device to the network in the future.
9. Click
Close
to complete WPS setup.
Page 103 / 120
99
D-Link DIR-608 User Manual
Section 4 - Connecting to a Wireless Network
Windows Vista®
Windows Vista® users may use the built-in wireless utility. If you are using another company’s wireless utility, please refer to the
user manual of your wireless adapter for help connecting to a wireless network. Most wireless utilities will have a “site survey”
option similar to the Windows Vista® utility as seen below.
Right-click on the wireless computer icon in your system tray (lower-right corner
next to the time). Select
Connect to a network
.
If you receive the
Wireless Networks Detected
bubble, click on the center of
the bubble to access the utility.
or
The utility will display any available wireless networks in your area. Click on a
network (displayed using the SSID) and click the
Connect
button.
If you get a good signal but cannot access the Internet, check you TCP/IP
settings for your wireless adapter. Refer to the
Networking Basics
section in
this manual for more information.
Page 104 / 120
100
D-Link DIR-608 User Manual
Section 4 - Connecting to a Wireless Network
WPA/WPA2
It is recommended that you enable wireless security (WPA/WPA2) on your wireless router or access point before configuring
your wireless adapter. If you are joining an existing network, you will need to know the security key or passphrase being used.
2.
Highlight the Wi-Fi name (SSID) you would like to connect to and click
Connect
.
1.
Open the Windows Vista® Wireless Utility by right-clicking on the wireless
computer icon in your system tray (lower right corner of screen). Select
Connect to a network
.
Page 105 / 120
101
D-Link DIR-608 User Manual
Section 4 - Connecting to a Wireless Network
3.
Enter the same security key or passphrase (Wi-Fi password) that is on your
router and click
Connect
.
It may take 20-30 seconds to connect to the wireless network. If the connection
fails, please verify that the security settings are correct. The key or passphrase
must be exactly the same as the one on the wireless router.
19216811.live