Page 81 / 97 Scroll up to view Page 76 - 80
81
D-Link DIR-600 User Manual
Section 11 - Connecting to an Unsecured Wireless Network
Connecting to an Unsecured Wireless
Network
The following are step-by-step directions to set up an unsecured wireless connection.
2.
Go to the
Network and Sharing Center
window and click
the
Manage Network Connections
link.
1. Click on
Properties
.
Page 82 / 97
82
D-Link DIR-600 User Manual
Section 11 - Connecting to an Unsecured Wireless Network
3.
Right-click the
Wireless Network Connection
entry and then select
Connect/Disconnect
from the drop-down menu.
4.
Select a network to connect to in the
Select a network to connect
to
window in the
Connect to a network
wizard and then click the
Connect
button.
5.
Con±rm your desire to connect anyway on the following
Network
Connection Status
window.
Page 83 / 97
83
D-Link DIR-600 User Manual
Section 11 - Connecting to an Unsecured Wireless Network
6.
The following
Connect to a network
wizard window displays the
system progress.
7.
The following
Successfully connected to dlink300
window in the
Connect to a network
wizard is displayed. Choose to save to the
network and/or start the new connection automatically. When you
are ±nished, click the
Close
button.
8.
The successful connection is displayed at the bottom of the Windows
start up menu.
Page 84 / 97
84
D-Link DIR-600 User Manual
Section 11 - Connecting to an Unsecured Wireless Network
9.
Con±rm your new settings by calling up the command prompt
and
then entering the ipcon±g command.
10.
To test the new IP address, use the Ping feature of the command
prompt.
Page 85 / 97
85
D-Link DIR-600 User Manual
Section 12 - Troubleshooting
Troubleshooting
This chapter provides solutions to problems that can occur during the installation and operation of the DIR-600.
Read
the following descriptions if you are having problems.
(The examples below are illustrated in Windows
®
XP.
If you
have a di²erent operating system, the screenshots on your computer will look similar to the following examples.)
1. Why can’t I access the web-based configuration utility?
When entering the IP address of the D-Link router (192.168.0.1 for example), you are not connecting to a website on
the Internet or have to be connected to the Internet. The device has the utility built-in to a ROM chip in the device itself.
Your computer must be on the same IP subnet to connect to the web-based utility.
• Make sure you have an updated Java-enabled web browser. We recommend the following:
• Internet Explorer 6.0 or higher
• Netscape 8 or higher
• Mozilla 1.7.12 (5.0) or higher
• Opera 8.5 or higher
• Safari 1.2 or higher (with Java 1.3.1 or higher)
• Camino 0.8.4 or higher
• Firefox 1.5 or higher
• Verify physical connectivity by checking for solid link lights on the device. If you do not get a solid link light, try using
a di²erent cable or connect to a di²erent port on the device if possible. If the computer is turned o², the link light may
not be on.
• Disable any internet security software running on the computer. Software firewalls such as Zone Alarm, Black Ice,
Sygate, Norton Personal Firewall, and Windows
®
XP ±rewall may block access to the con±guration pages. Check the
help ±les included with your ±rewall software for more information on disabling or con±guring it.

Rate

4.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top